Samsung DV5471A Series User Manual page 21

Method2 - Using the Short Hose, Long Hose, and Y Connector
The dryer must be connected to the cold water faucet using the new inlet hoses. Do not use old
hoses.
If the "Y" connector cannot be attached directly to the cold water faucet, then you must use the
short hose.
t_ Turn off the cold water faucet.
2. If you have a washer water hose attached to the cold water
faucet, unscrew and remove the hose.
3. Attach the short inlet hose to the cold water faucet. Screw
on the coupling by hand until it is tight.
4. Using pliers, tighten the coupling with an additional two
thirds turn.
_Do not overtighten. You can damage the coupling.
5. Attach the 'Y" connector to the stainless male end of the
small hose. Screw on the coupling by hand until it is tight.
6. Using pliers, tighten the coupling with an additional two
thirds turn.
[_Do overtighten, can damage coupling.
not You the
7. Attach the angled end of the long hose to the fill valve at the
bottom of the dryer rear frame. Screw on the coupling by
hand until it is tight.
8. Using pliers, tighten the coupling with an additional two
thirds turn.
[_Do overtighten, can damage coupling.
not You the
9_ Turn the water faucet on.
t 0. Check for leaks around "Y" connector, faucets, and hoses.
Contents 21
DV5471AE-03022A-01 EN.indd Sec2:21 2011-03-28 3:44:41