Connecting The Inlet Hose - Samsung DV5471A Series User Manual

CONNECTING THE INLET HOSE
Method1 - Using the Y Connector and Long Hose
The dryer must be connected to the cold water faucet using the new inlet hoses. Do not use old
hoses.
t. Turn off the cold water faucet. _ /
2. If you have awasher water hose attached to the cold water '1 _r_r"_ _Y-C ..... ter
faucet, unscrew and remove the hose. __
3. If space permits, attach the brass female end of the _f_,_:)
"Y"connector to the cold water faucet. Turn by hand until __ -
tight. _ X I
4. Attach the straight end of the long hose to the "Y' connector. Water Hose_
Screw on the hose coupling by hand until it is tight.
5. Using pliers, tighten the hose coupling with an additional two_----4_c uct
Exhaust'
/
thirds turn. _ _ .._
Do not overtighten. You can damage the coupling. _.___ __ba_
6. Attach the angled end of the long hose to the fill valve at the _ _d_ / /
bottom of the dryer's rear frame. Screw on the coupling by _ //_'J / /
hand until it is tight. _ - 7_ / f_
7. Using pliers, tighten the hose coupling with an additional two /_//f_ _/
,_r thirds turn. f//_._w_ter h, se_
Do not overtighten. You can damage the coupling. / / /
8. Attach the washer hose to the other side of the "Y" connector, Screw on the hose coupling until
it is tight. Using pliers, tighten the coupling with an additional two thirds turn.
Do not overtighten. You can damage the coupling.
9. Turn the water faucet on.
t O. Check for leaks around "Y" connector, faucets, and hoses.
20 Contents
DV5471AE-03022A-01 EN.indd Sec2:20 2011-03-28 3:44:40 I