Changing The Water Filter - Samsung RF4289HA User Manual

Hide thumbs Also See for RF4289HA:
Table of Contents

Advertisement

CHANGING
THE WATER FILTER
"
WARNING
To reduce risk of water damage to your
property
DO NOT use generic brands of
water filters in your SAMSUNG
Refrigerator.
USE ONLY SAMSUNG
BRAND
WATER
FILTER.
SAMSUNG
will not be legally
responsible
for any damage,
including,
but
not limited to property
damage caused by
water leakage from use of a generic water
filter. SAMSUNG
Refrigerators
are designed
to work ONLY WITH SAMSUNG
Water Filter.
The Water Filter status icon on the Home
screen enables you to check the filter current
status of the water filter.
The Filter icon turns red to let you know when it
_Red_
iS time to change your water filter cartridge.
To give you time to get a new filter, the red icon comes
on just before the capacity of the current filter runs
out. Changing
the filter on time provides you with the
freshest,
cleanest water from your refrigerator.
1.
Shut off the water supply. Then, turn the water
filter ( 1 ) about 1/4 turn, counter-clockwise.
2.
Pull the water filter ( 1 ) from the case filter ( 2 ).
%
o
To change the water filter more easily, shut
off the water supply valve.
o
Sometimes,
it is hard to disassemble
the water
filter because
impurities
in the water cause it to
stick. If you are having difficulties,
grip the water
filter firmly and pull it hard.
o
When you pull the water filter, a little water can
leak from the opening.
This is normal.
To minimize the water leaks, keep the filter
cartridge
horizontal when you pull it.
o
To prevent overflow, empty the water tray filter ( 3 )
and dry around of case filter ( 2 ).
3.
Insert the new filter into the --
filter case ( 4 )
4.
Push the filter, and then turn
it clockwise
until it locks.
o
If you are in trouble
of inserting the water
filter as high pressure of water, shut off the
water supply valve.
.
The locked symbol should be lined up with the
indicator
line.
f
When the replacement
is done,
touch and hold the 'Reset the
water filter' simultaneously
for 3 or
more seconds
at the center of the
screen. (Refer to page 56)
6.
If you turned off the water supply, turn it back on.
For a replacement
water filter, you can visit your
local home Improvement
center or contact the
Samsung
Parts distributor.
Be sure the replacement
water filter has the
SAMSUNG
logo on the box and on the water
filter.
Link: http://www.samsungparts.com
Removing
any
residual
matter
inside
the water
supply
line after
installing
the water
filter.
1.
Turn ON the main water supply and supply water
from water supply line.
2.
Run water through the dispenser
until the water
runs clear (approx. 6 to 7 minutes).
This will clean the water supply system and
remove air from the lines.
3.
Additional
flushing may be
required in some households.
4.
Open the Refrigerator
door and
make sure there are no water
leaks coming from the water
filter.
Be sure to flush the dispenser
thoroughly,
otherwise
water may drip from the dispenser.
This means that there is still air in the line.
70 operating

Advertisement

Table of Contents
loading

Table of Contents