Samsung RF4289HA User Manual page 12

Refrigerator
-- Compression
Plastic tubing nut (A) (1/4")
(A) (Supplied) (Supplied)
t
[_ Compression
fitting (Supplied)
Ferrule (Not '--_--._ :: i Molded
supplied end(Bulb)
Compression nut
(sBu)p(pl _4_) (N°t
Copper tubing or Plastic tubing (B)
(Not supplied) (Not supplied)
lm
2.
Slip the compression nut ( A ) through the supplied
plastic tubing ( A ).
Tighten the compression nut ( A ) onto the 1/4"
compression fitting.
If you are using copper tubing, slip the
compression nut ( B ) (not supplied) and ferrule
(not supplied) on copper tubing (not supplied) as
shown.
If you are using plastic tubing ( B ), insert the
molded end (Bulb) of the plastic tubing ( B ) into
the compression fitting.
Do not without the molded of
use end(Bulb)
CAUTIONthe plastic tubing ( B ).
3. Tighten the compression nut ( B ) onto the
compression fitting.
Do not over-tighten the compression nut ( B ).
4. Turn water on and check for any leakage. If you
find water drops or leakage in the connection
areas, turn off the main water supply.
Check the connections and, if nescessary, tighten.
5. Flush 1 gallon of water through the filter before
drinking or using the water from the refrigerator.
(Flush approximately 6 minutes.)
To flush, press a large glass or cup against the
water dispenser lever.
Fill the glass, empty it into the kitchen sink after it
is filled, and then repeat.
m
After you turn on the refrigerator, let the ice maker
make ice for 1 to 2 days.
Over that period of time, throw out the first 1 or
2 buckets of ice the freezer makes to ensure all
impurities have been removed from the water line.
®
Only connect the water line to a drinkable water
source.
If you have to repair or disassemble the water
line, cut off 1/4" of the plastic tubing to make
sure you get a snug, leak-free connection.
COMPLETING THE SET UP
Now that you have your new refrigerator installed in
place, you are ready to set up and enjoy the features
and functions of the appliance.
By completing the following steps, your refrigerator
should be fully operational.
1. Make sure your refrigerator is in an appropriate
location with reasonable clearance between it and
the wall.
Refer to installation instructions in this manual.
2. Once the refrigerator is plugged in, make sure the
interior light comes on when you open the doors.
3. Set the Temperature control to the coldest
temperature and wait for an hour.
The freezer will get slightly chilled and the motor
will run smoothly. Reset the refrigerator and freezer
to the temperatures you want.
4. After you plug the refrigerator in, it will take a few
hours to reach the appropriate temperature.
You can store food and drinks in the refrigerator
after the temperature is sufficiently cool.
12 setting up