Connecting To A Vcr; Connecting An S-Vhs Vcr - Samsung LN-S4095D Owner's Instructions Manual

Connecting a VCR
These instructions assume that you have already connected your TV to an antenna or a cable TV system (according to the instructions
on pages 8 9). Skip step 1 if yon have not yet connected to an antenna or a cable system.
1. Unplug the cable or
antenna from the back
of the TV.
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
__iiiiiiiiiiiiiiiiiiiiiiiiiii_ ..... _li_!_!_i_iiii_ii_ii_ii_ii_ii_i_!_!_!_i_i_ii_i_ii_i_i_!_!_!_!_!_!!!_i_ii_i_!_i _ i!ii!ii_iiiiii_i_!i!_!_!___ii_i_i_
TV Rear Panel
Follow the instructions in "Viewing a VCR or Camcorder Tape" to view your VCR tape.
_,_ Each VCR has a different back panel configuration.
>,- When connecting a VCR, match the color of the connection terminal to the cable.
_,_ We recommend the use of cables with a Ferrite Core.
2. Connectthe cable or
antenna to the ANT IN
terminal on the back
of the VCR.
3. Connectan RF Cable
between the ANT OUT
terminal on the VCR and
the ANT 1 IN (AIR) or
ANT 2 IN (CABLE)
terminal on the TV.
4. Connect a Video Cable
between the VIDEO OUT
jack on the VCR and the
AV IN 1 (orAV IN 2)
[VIDEO] jack on the TV.
5. Connect Audio Cables
between the AUDIO OUT
jacks on the VCR and
the AV IN 1 (orAV IN 2)
[R-AUDIO-L[ jacks
on the TV.
If you have a 'mono"
(non-stereo) VCR, use a
%connector (not supplied)
to hook up to the right
and left audio input jacks
of the TV. If your VCR
is stereo, you must
connect two cables.
Connecting an S-VHS VCR
Your Samsung TV can be connected to an S-Video signal fi'om an S VHS VCR.
This connection delivers a better picture as compared to a standard VHS VCR.)
TV Rear Panel
VCR Rear Panel
An S-Video cable is usually included with an S-VHS VCR. (If not, check your local electronics store.)
>- Each S-VHS VCR has a different back panel configuration.
:_- When connecting an S-VHS VCR, match the color of the connection terminal to the cable.
_-- We recommend the use of cables with a Ferrite Core.
1. To begin, follow steps 1-3
in the previous section to
connect the antenna or
cable to your VCR and
your TV.
2. Connect an S-Video Cable
between the S-VIDEO OUT
jack on the VCR and the
AV IN1 [S-VIDEO] jack on
the TV.
3_
Connect Audio Cables
between the AUDIO OUT
jacks on the VCR and the
AV IN1 [R-AUDIO-L] jacks
on the TV.
English- 10