Lcd Screen Safety - Epson Stylus NX625 Series Quick Manual

■
Do not use aerosol products that contain flammable gases inside or around the
product. Doing so may cause fire.
■
Do not press too hard on the document table when placing the original.
■
Do not open the scanner section while the product is copying, printing, or scanning.
■
Do not touch the flat white cable inside the product.
■
Be careful not to trap your fingers when closing the document cover or scanner.
■
Do not spill liquid on the product.
■
Adjust only those controls that are covered by the operating instructions. Except as
specifically explained in your documentation, do not disassemble, modify, or attempt
to service the product or power cord yourself.
■
Unplug the product and refer servicing to qualified service personnel under the
following conditions: if the power cord or plug is damaged; if liquid has entered the
product; if the product has been dropped or the case damaged; if the product does not
operate normally or exhibits a distinct change in performance.
■
When storing or transporting the product, do not tilt it, stand it on its side, or turn it
upside down; otherwise ink may leak from the cartridges.
■
When connecting the printer to a computer or other device with a cable, ensure the
correct orientation of the connectors. Each connector has only one correct
orientation. Inserting a connector in the wrong orientation may damage both devices
connected by the cable.
■
Allow spaces behind the printer for the cables, and space above the printer so that you
can fully raise the document cover.
■
Do not move the print head by hand; otherwise, you may damage the printer.
■
Before transporting the printer, make sure that the print head is in the home (far
right) position and the ink cartridges are in place.

LCD Screen Safety

■
Use only a dry, soft cloth to clean the LCD screen. Do not use liquid or chemical
cleansers.
■
If the LCD screen is damaged, contact Epson. If the liquid crystal solution gets on
your hands, wash them thoroughly with soap and water. If the liquid crystal solution
gets into your eyes, flush them immediately with water. If discomfort or vision
problems remain after a thorough flushing, see a doctor immediately.
52
Notices