Table of Contents
Advertisement
Label
ing
the
Channels
This last step in the Interactive
Setup lets you edit your channel list and
label your channels. (For more, see List and Labels in the Using the
Menus section.)
Use the CH ^ (channel up) or CH v
(channel down) buttons
to change
channels in the Chart # field. This works
even if you're not in the Chart # field. Or,
enter the channel number
directly
using
the number
buttons
on the universal
remote.
To enter a number greater than
99, press and hold "1" to enter the
hundreds digit, then press the two
remaining
numbers.
The list and labels feature can also be
accessed from the Channel menu. Because
this procedure
can be time consuming,
feel free to skip this step and come back
to it later.
1.
Press MENU or OK to bring up the LISTAND LABELS control
panel.
2,
3.
4,
Use the left and right arrows to point to the three different
areas of
the control
panel (called "fields").
Use the up and down arrows to scroll through
the numbers and
letters and select Yes or No in the Normal List field. You may wish to
refer to the call letters listed in your newspaper's
TV section for ideas
on labeling
the channels.
Repeat this process for each of your channels. Then press MENU or
OK to continue.
The TV can store up to 27 labels in memory.
Programming
the
Remote
Since you've gone this far, you can take a few minutes to program
the
remote to control
your VCR, satellite
receiver, or other components.
To
find out how to program
the remote, go to the next section.
2O
Advertisement
Table of Contents
