RCA F36685YX1CN User Manual page 46

2. Press MENU to highlight the Menu bar.
3. Use the right and left arrows to highlight the Editor menu selection.
4. Use the up and down arrows to select a channel.
Then use the Editor Menu Action Buttons as described in the next section.
Editor Menu Action Buttons
While browsing the Editor menu, the following Action buttons are
available on the bar:
Cancel Press 1 on the remote to cancel any changes made since
entering the Editor Menu.
Change Press 2 on the remote to change the channel number for
the highlighted channel line.
On/Off Press 3 on the remote to toggle the state of the channel
between On and Off.
Expanded Information
To view more information about a program, advertisement or special,
highlight the channel listing or ad/show information box and press the
INFO button. Requesting more information about a particular show will
also display the PlusCode programming number and the Shows on Next for
that channel.
Pressing INFO while highlighting an ad panel will fill the screen with any
additional and/or promotional information regarding that particular
program.
Pressing the INFO button again exits the expanded information screen.
Troubleshooting
Troubles sometimes are caused by simple "faults" that you can correct
without a service technician. Here are a few basic remedies:
Program information does not download
Review your setup information and make sure it is correct.
The TV must be off to download information. Leave your TV off
overnight, for at least 10 hours, to receive a download for your area.
If you are using a cable box, make sure the cable box is on in order to
receive program information.
if you are using a VCR, make sure the VCR is off in order to receive
program information.
Scheduled Watch or Record does not occur
Check Schedule for timer conflicts.
Check that IR controllers are attached securely and directly over the
remote sensor.
Make sure there is a tape in hte VCR and that the VCR is properly
44
connected.
]
Ad/Show Information