Daily Use - Zanussi ZWS 688 User Manual

measure of detergent into the main wash
compartment and start the machine.

Daily use

Load the laundry
Measure out the detergent and the fabric
softener
Pull out the dispenser drawer until it stops.
Measure out the amount of detergent re-
quired, pour it into the main wash compart-
ment or in the appropriate compartment if
the selected programme/option it requires
(see more details in "Detergent dispenser
drawer").
If required, pour fabric softener into the com-
partment marked
not exceed the «MAX» mark in the drawer).
Close the drawer gently.
8
Open the door by
carefully pulling the
door handle out-
wards. Place the
laundry in the drum,
one item at a time,
shaking them out as
much as possible.
Close the door.
Make sure that no
laundry stays be-
tween the seal and
the door. There is a
risk of water leakage
or damage to the
laundry.
(the amount used must
Select the required programme by turning
the programme selector dial (1)
Turn the programme selector dial to the re-
quired programme. The washing machine will
automatically select the maximum spin value
provided for the programme you have chosen.
You can change this value by pressing the cor-
responding button. The green pilot light of the
button 5 starts to flash.
The selector dial can be turned either clockwise
or counterclockwise. Turn to position
set programme/Switching the machine off.
At the end of the programme the selector
dial must be turned to position
switch the machine off.
Caution! If you turn the programme
selector dial to another programme when
the machine is working, the red pilot light of
button 5 will blink 3 times to indicate a wrong
selection. The machine will not perform the new
selected programme.
Select the spin speed, No Spin or Rinse
Hold option by pressing button 2
The relevant light will light up.
When selecting a programme, the light corre-
sponding to the maximum speed allowed for
that programme will illuminate.
Select the available options by pressing
buttons 3 and 4
Depending on the programme, different func-
tions can be combined. These must be selected
after choosing the desired programme and be-
fore starting the programme.
When these buttons are pressed, the corre-
sponding pilot lights illuminate. When they are
pressed again, the pilot lights go out. If an incor-
rect option is selected, the integrated red pilot
light of the button 5 flashes for 3 times.
For the compatibility among the washing
programmes and the options see chapter
«Washing Programmes».
to re-
, to
www.zanussi.com