Zanussi ZWS 688 User Manual page 20

After removing all the
packaging, carefully
lay machine on it's
back to remove the
polystyrene base from
the bottom.
Unscrew the three
bolts.
Fill the smaller upper hole and the two large
ones with the corresponding plastic plug caps
supplied in the bag containing the instruction
booklet.
Positioning
Install the machine on a flat hard floor. Make
sure that air circulation around the machine is
not impeded by carpets, rugs etc. Check that
the machine does not touch the wall or other
kitchen units. Level the washing machine by
raising or lowering the feet. The feet may be
tight to adjust as they incorporate a self locking
nut, but the machine MUST be level and stable.
20
Remove the power
supply cable and the
hoses from the hose
holders on the rear of
the appliance.
Slide out the relevant
plastic spacers.
Any necessary adjustment can be made with a
spanner.
Accurate levelling prevents vibration, noise and
displacement of the machine during operation.
Never place cardboard, wood or similar materi-
als under the machine to compensate for any
unevenness in the floor.
Water inlet
Caution!
• This appliance must be connected
to a cold water supply.
• Before connecting up the appliance to
new pipework or to pipework that has
not been used for some time, run off a
reasonable amount of water to flush out
any debris that may have collected.
• Do not use the hose from your previous
appliance to connect to water supply.
The inlet hose is supplied with the appliance
and can be found inside the machine drum.
35°
If necessary, check
the setting with a spi-
rit level.
45°
www.zanussi.com