Edimax Wireless LAN Access Point User Manual page 21

RTS Threshold
Beacon Interval
Data Rate
Preamble Type
Broadcast ESSID
IAPP
Click Apply button at the bottom of the screen to save the above configurations. You can now configure
other advance sections or start using the Access Point.
result in bad performace.
When the packet size is smaller the RTS threshold, the access point will
not use the RTS/CTS mechanism to send this packet.
The interval of time that this access point broadcast a beacon. Beacon is
used to synchronize the wireless network.
The "Data Rate" is the rate this access point uses to transmit data
packets. The access point will use the highest possible selected
transmission rate to transmit the data packets.
Preamble type defines the length of CRC block in the frames during the
wireless communication. "Short Preamble" is suitable for high traffic
wireless network. "Long Preamble" can provide more reliable
communication.
If you enable "Broadcast ESSID", every wireless station located within
the coverage of this access point can discover this access point easily. If
you are building a public wireless network, enabling this feature is
recommended. Disabling "Broadcast ESSID" can provide better security.
If you enable "IAPP", the access point will automatically broadcast
information of associated wireless stations to its neighbors. This will help
wireless station roaming smoothly between access points. If you have
more than one access points in your wireless LAN and wireless stations
have roaming requirements, enabling this feature is recommended.
Disabling "IAPP" can provide better security.
19
Wireless LAN Access Point Configuration