Table of Contents
Advertisement
4. Please check all the LEDs on the front panel. The "PWR" and "WAN" LEDs should be
on. The "LAN" LED should be on if the computer is connected and correctly
powered. If you encounter any problems, please make sure that all your devices
are connected and powered correctly.
2‐2 Setting Client Computers to Obtain IP Addresses Automatically
Before you start configuration procedures, your computer must be able to get an IP address
automatically (set to use dynamic IP addresses). If your computer is set to use a static IP
address, or if you are unsure, please follow the following instructions to configure your
computer to use dynamic IP addresses:
Windows 95/98/Me
Windows 2000
Windows XP
Windows Vista
2‐2‐1 Windows 95/98/Me IP Address Setup
1. Click the "Start" button (it should be located at the lower‐left corner of your
screen), then click "Control Panel". Double‐click the "Network" icon, and the
"Network" window will appear. Select "TCP/IP", and then click "Properties".
(see section 2‐2‐1)
(see section 2‐2‐2)
(see section 2‐2‐3)
(see section 2‐2‐4)
7
Advertisement
Table of Contents
