Table of Contents
Advertisement
Associated Clients
Wireless Module
Click "Apply" to save the changes, or click "Cancel" to discard the changes. After you have
clicked "Apply", you will see the following message:
Click "Apply" to save the changes and restart the broadband router. It takes about 60
seconds for the broadband router to restart. Click "Continue" to configure other settings.
3‐4‐1‐2 Station‐Infrastructure
In "Station‐Infrastructure" mode, the router acts as a wireless communication client and
provides wired communication for other wired devices. The following settings will appear in
"Station‐Infrastructure" mode:
select the channel of your preference (1 to 13).
Click "Show Active Clients" for the list of all
connected wireless clients. Click "Refresh" in the
new window to renew the list, and click "Close" to
close the window.
Note: If you have a pop‐up blocker installed, you
may have to disable it, or set it to allow the pop‐up
window to show up.
Select "Enable" to turn on the 2.4GHz wireless
signal and select "Disable" to turn it off.
39
Advertisement
Table of Contents
