Whirlpool Duet GEW9260 Use & Care Manual page 8

Power Supply Cord Direct Wire
Fire Hazard
Use a new UL listed 30 amp power supply cord.
Use a UL _isted strain relief,
Disconnect power before making e_ectdcal connections.
Connect neutral wire (white or center wire) to center
terminal (silver),
Ground wire (green or bare wire) must be connected to
green ground connector.
Connect remaining 2 supply wires to remaining
2 terminals (gotd).
Securely tighten aimelectrical connections,
Failure to do so can result in death, fire, or
e_ectrical shock,
1. Disconnect power,
2. Remove the hold-down screw and terminal block cover.
D
Fire Hazard
Use 10 gauge solid copper wire,
Use a UL listed strain relief,
Disconnect power before making e_ectrica_ connections.
Connect neutral wire (white or center wire) to center
terminal (silver).
Ground wire (green or bare wire) must be connected to
green ground connector,
Connect remaining 2 supply wires to remaining
2 terminals (gold).
Securety tighten a_ e_ectrica{ connections.
Failure to do so can result in death, fire, or
electrical shock.
3. Assemble a 3/4"(1.9 cm) UL listed strain relief (UL marking on
strain relief) into the hole below the terminal block opening.
Tighten strain relief screws just enough to hold the two clamp
sections together. Put power supply cord through the strain
relief, The strain relief should have a tight fit with the dryer
cabinet and be in a horizontal position.
A. Neutral grounding wire (green/yellow)
B. External ground conductor screw
C. Center, silver-colored terminal block screw
D. Terminal block cover and hold-down screw
Now complete installation following instructions for your type
of electrical connection:
4-wire (recommended)
3-wire (if 4-wire is not available)