Table of Contents
Advertisement
When using Air Only
•
Check to see that coverings are securely stitched.
•
Shake and fluff pillows by hand periodically during the cycle.
•
Dry item completely.
Foam rubber pillows are slow to dry.
NOTE: Automatic
Cycles are not available when using the Air
Only setting.
Signals
The Dry Only setting produces an audible sound when the drying
cycle is finished. Promptly removing clothes at the end of the
cycle reduces wrinkling.
The Damp & Dry Signal is useful when drying bedsheets/linens
in
a mixed load or large items in the "Bulky Items" cycle. When the
signal sounds, rearrange the load inside the dryer, close the door
and restart the dryer to finish the drying cycle. Rearranging the
load will aid in the drying process.
For the "Bulky Items" cycle, "Damp & Dry" is preset to ON.
0 Damp& Dr7
0 Dr7Only
o off
©
Signds
Hold for 3 Seconds to
Lock / Unlock Contlol
Press and release the SIGNALS button to change the setting.
NOTE: When the WRINKLE SHIELD
TM
feature is selected and the
Signals setting is on, an audible sound will emit every 5 minutes
until the clothes are removed, or the WRINKLE SHIELD
TM
feature
is finished.
The drying rack is useful for drying items you would not
necessarily want to tumble dry or that you would normally line dry
(for example, sweaters).
To use the drying rack
Do not remove the lint screen.
1. Open dryer door.
A
A. Front edge
2. Place drying rack inside dryer drum, positioning the back wire
on the ledge of the inner dryer back panel. Push down on
front edge of drying rack to secure over the lint screen.
3. Put the wet items on top of the rack. Leave space between
the items so air can reach all the surfaces.
NOTE: Do not allow items to hang over the edge of the rack.
4. Close the door.
5. Select a timed drying cycle and temperature, or an air cycle
(see following chart). Items containing foam, rubber, or plastic
must be dried on a clothesline or by using the Air Only
temperature setting.
6. You must select a time by pressing MORE TIME or LESS
TIME. Reset time as needed to complete drying. Refer to the
following table.
7. Press (and hold) HOLD TO START button (about 1 second).
NOTE: You must remove rack for normal tumbling.
Do not use
automatic cycles with the drying rack.
This chart shows examples of items that can be rack dried and
the suggested cycle, temperature setting and drying time. Actual
drying time will depend on the amount of moisture items hold.
Rack Dry
Setting
Temp.
Time*
Wool Sweaters
Timed
Low
60
Block to shape and lay flat on
Dry
the rack.
Stuffed toys or pillows
Timed
Low
60
Cotton or polyester fiber filled
Dry
Stuffed toys or pillows
N/A
Air Only
90
Foam rubber filled
(no
heat)
Sneakers or canvas shoes
N/A
Air Only
90
(no
heat)
*(Minutes) Reset time to complete drying, if needed.
A
A. Dryer back panel
20
Advertisement
Table of Contents
