Dryer Use - Whirlpool Duet GEW9260 Use & Care Manual

DRYER USE
dentin/On
0 Hsgh
0 Medium
0 Low 0 Damp & Dry
0 Extra Low 0 Dly Only
0 Aft Only 0 Off
Temperature 5i#nal5
(Mon,,oJ cycles oJrM Hold _o, 3 Seconds _o
ock / u_mck Co,,trd
J
Explosion Hazard
Keep fiammabme materiams and vapors, such as
gasoline, away from dryer.
Do not dry anything that has ever had anything
flammabBe on it (even after washing).
Failure to follow these instructions can result in death,
explosion, or fire.
Fire Hazard
No washer can compmeteBy remove oil.
Do not dry anything that has ever had any type of oH on
it (incmuding cooking oils).
Items containing foam, rubber, or pBastic must be dried
on a cmothesBine or by using an Air Cycle.
Failure to folmow these instructions can result in death
or fire.
The following is a guide to starting your dryer. Please refer to
specific sections of this manual for more detailed information.
1. Clean lint screen before or after each cycle. See "Cleaning
the Lint Screen."
2. Place laundry into dryer and shut door. See "Loading."
3. Rotate the dial to select either an Automatic or Manual Cycle
then press the CONTROL ON button. The preset settings and
drying time for the cycle chosen will be displayed.
To use an Automatic Cycle
Point the dial to an Automatic Cycle.
Select DRYNESS LEVEL to adjust how dry you want the
load to be. The time displayed is an estimated length of
the cycle based on the Dryness Level selected. As the
cycle runs, the control senses the dryness of the load and
adjusts the time automatically for the selected Dryness
Level.
0 More
0
0 Less
©
Dryness
Levd
NOTE: Time is not adjustable for Automatic Cycles. Pressing
the More Time or Less Time buttons will cause a triple beep,
indicating that the time cannot be changed.
• Press the WRINKLE SHIELD
TM
feature button if this
option is desired.
• Press the SIGNALS button to set the desired signal
setting.
• Press (and hold) HOLD TO START button until dryer starts
(about 1 second).
Once an Automatic cycle has started, the WRINKLE
SHIELD
TM
feature and cycle signals can be adjusted. Press
the PAUSE/CANCEL key twice to stop the dryer and clear the
settings, allowing you to select another cycle and Dryness
Level.
WARNING: To reduce the risk of fire, electric shock, or injury to
persons, read the IMPORTANT SAFETY INSTRUCTIONS before
operating this appliance.
16