Connect Hose And Water Supply To Pump - Troy-Bilt Pressure Washer Operator's Manual

2550 psi
Hide thumbs Also See for Pressure Washer:
Table of Contents

Advertisement

Available languages

Available languages

Connect Hose and Water Supply to Pump

NOTICE
DO NOT run the pump without the water supply connected
and turned on.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
NOTE: Remove and discard the shipping caps from the
pump's high pressure outlet and water inlet before attaching
hoses.
1. Uncoil high pressure hose and attach one end of hose
to base of spray gun. Tighten by hand.
WARNING
The high pressure stream of water that this
equipment produces can cut through skin and its
underlying tissues, leading to serious injury and
possible amputation.
• NEVER connect high pressure hose to nozzle extension.
• Keep high pressure hose connected to pump and spray gun
while system is pressurized.
• Always be certain spray gun, nozzles and accessories are
correctly attached.
2. Attach other end of high pressure hose to high
pressure outlet on pump. Tighten by hand.
3. Before connecting garden hose to water inlet, inspect
inlet screen (A). Clean screen if it contains debris or
have it replaced if damaged. DO NOT run pressure
washer if inlet screen is damaged.
10
4. Run water through your garden hose for 30 seconds to
IMPORTANT: DO NOT siphon standing water for the water
supply. Use ONLY cold water (less than 100°F (38°C)).
5. Connect the garden hose (not to exceed 50 feet (15 m)
Using a One Way Valve (vacuum breaker or check valve)
at pump inlet can cause pump or inlet connector damage.
• There MUST be at least ten feet (3 m) of unrestricted garden
hose between the pressure washer inlet and any device, such as
a vacuum breaker or check valve.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
6. Turn ON the water and squeeze the trigger on the spray
• Always wear safety goggles when using this equipment or in
vicinity of where equipment is in use.
• Before starting the pressure washer, be sure you are wearing
adequate safety goggles.
• NEVER substitute safety glasses for safety goggles.
Checklist Before Starting Engine
Review the unit's assembly to ensure you have performed all
of the following.
1. Be sure to read the Operator Safety section and How to
2. Make sure handle is in place and secure.
3. Check that oil has been added to proper level in the
4. Add proper fuel to fuel tank.
5. Check for properly tightened hose connections.
6. Check to make sure there are no kinks, cuts, or damage
7. Provide a proper water supply at an adequate flow.
A
clean out any debris.
in length) to the water inlet. Tighten by hand.
NOTICE
gun to purge the pump system of air and impurities.
WARNING
Risk of eye injury.
Spray can splash back or propel objects.
Use Your Pressure Washer in Operation section before
using pressure washer.
engine crankcase.
to high pressure hose.
www.troybilt.com

Hide quick links:

Advertisement

Chapters

Table of Contents
loading

This manual is also suitable for:

2550 psi020348-0

Table of Contents