Dell Broadcom NetXtreme Family of Adapters User Manual page 87

iSCSI Protocol: Broadcom NetXtreme II Network Adapter User Guide
29 Error
30 Error
31 Error
32 Information Initiator received an asynchronous logout message. The Target name is given in the dump data.
33 Error
34 Information
35 Error
36 Error
37 Error
38 Error
39 Error
40 Error
41 Error
42 Error
43 Error
44 Error
45 Error
46 Error
47 Error
48 Error
49 Error
50 Error
51 Error
52 Error
53 Error
54 Error
55 Error
56 Error
57 Error
58 Error
59 Error
60 Error
61 Error
62 Error
63 Error
64 Information Attempt to bootstrap Windows using iSCSI NIC Boot (iBF).
65 Error
66 Error
67 Information If Digest support selected for iSCSI Session, will use Processor support for Digest computation.
68 Error
69 Error
file:///T|/htdocs/NETWORK/BroadCom/71921/NetXtremeII/en/iscsi.htm[9/26/2012 3:29:03 PM]
Target rejected an iSCSI PDU sent by the initiator. Dump data contains the rejected PDU.
Initiator could not allocate a work item for processing a request.
Initiator could not allocate resource for processing a request.
Challenge size given by the target exceeds the maximum specified in iSCSI specification.
A connection to the target was lost, but Initiator successfully reconnected to the target. Dump data
contains the target name.
Target CHAP secret is smaller than the minimum size (12 bytes) required by the specification.
Initiator CHAP secret is smaller than the minimum size (12 bytes) required by the specification.
Dump data contains the given CHAP secret.
FIPS service could not be initialized. Persistent logons will not be processed.
Initiator requires CHAP for logon authentication, but target did not offer CHAP.
Initiator sent a task management command to reset the target. The target name is given in the
dump data.
Target requires logon authentication via CHAP, but Initiator is not configured to perform CHAP.
Target did not send AuthMethod key during security negotiation phase.
Target sent an invalid status sequence number for a connection. Dump data contains Expected Status
Sequence number followed by the given status sequence number.
Target failed to respond in time for a login request.
Target failed to respond in time for a logout request.
Target failed to respond in time for a login request. This login request was for adding a new
connection to a session.
Target failed to respond in time for a SendTargets command.
Target failed to respond in time for a SCSI command sent through a WMI request.
Target failed to respond in time to a NOP request.
Target failed to respond in time to a Task Management request.
Target failed to respond in time to a Text Command sent to renegotiate iSCSI parameters.
Target failed to respond in time to a logout request sent in response to an asynchronous message
from the target.
Initiator Service failed to respond in time to a request to configure IPSec resources for an iSCSI
connection.
Initiator Service failed to respond in time to a request to release IPSec resources allocated for an
iSCSI connection.
Initiator Service failed to respond in time to a request to encrypt or decrypt data.
Initiator failed to allocate resources to send data to target.
Initiator could not map an user virtual address to kernel virtual address resulting in I/O failure.
Initiator could not allocate required resources for processing a request resulting in I/O failure.
Initiator could not allocate a tag for processing a request resulting in I/O failure.
Target dropped the connection before the initiator could transition to Full Feature Phase.
Target sent data in SCSI Response PDU instead of Data_IN PDU. Only Sense Data can be sent in
SCSI Response.
Target set DataPduInOrder to NO when initiator requested YES. Login will be failed.
Target set DataSequenceInOrder to NO when initiator requested YES. Login will be failed.
Cannot reset the target or LUN. Will attempt session recovery.
Booting from iSCSI, but could not set any NIC in Paging Path.
Attempt to disable the Nagle Algorithm for iSCSI connection failed.
After receiving an async logout from the target, attempt to relogin the session failed. Error status is
given in the dump data.
Attempt to recover an unexpected terminated session failed. Error status is given in the dump data.