Dell Broadcom NetXtreme Family of Adapters User Manual page 123

Broadcom Teaming Services: Broadcom NetXtreme II Network Adapter User Guide
5 Informational configured for 10Mb
6 Informational
7 Informational
8 Informational
9 Informational
10 Error
11 Error
12 Informational
13 Error
14 Error
15 Error
Please read all Restrictions and
Back to Contents Page
file:///T|/htdocs/NETWORK/BroadCom/71921/NetXtremeII/en/teamsvcs.htm[9/26/2012 3:29:14 PM]
full-duplex link.
Network controller
configured for 100Mb
half-duplex link.
Network controller
configured for 100Mb
full-duplex link.
Network controller
configured for 1Gb half-
duplex link.
Network controller
configured for 1Gb full-
duplex link.
Unable to register the
interrupt service
routine.
Unable to map IO
space.
Driver initialized
successfully.
Driver initialization
failed.
This driver does not
support this device.
Upgrade to the latest
driver.
This driver fails
initialization because
the system is running
out of memory.
Disclaimers.
manually configured for
the selected line speed
and duplex settings.
The adapter has been
manually configured for
the selected line speed
and duplex settings.
The adapter has been
manually configured for
the selected line speed
and duplex settings.
The adapter has been
manually configured for
the selected line speed
and duplex settings.
The adapter has been
manually configured for
the selected line speed
and duplex settings.
The device driver cannot
install the interrupt
handler.
The device driver cannot
allocate memory-
mapped
I/O to access driver
registers.
The driver has
successfully loaded.
Unspecified failure during
driver initialization.
The driver does not
recognize the installed
adapter.
Insufficient system
memory prevented the
initialization of the
driver.
No action is required.
No action is required.
No action is required.
No action is required.
No action is required.
Reboot the operating system; remove other
device drivers that may be sharing the same
IRQ.
Remove other adapters from the system, reduce
the amount of physical memory installed, and
replace the adapter.
No action is required.
Reinstall the driver, update to a newer driver,
run Broadcom Advanced Control Suite
diagnostics, or replace the adapter.
Upgrade to a driver version that supports this
adapter.
Increase system memory.