Troy-Bilt AutoDrive 604 Operator's Manual page 19

Hide thumbs Also See for AutoDrive 604:
Table of Contents

Advertisement

- Remove t he deckbeltfrom
the electric PI"O clutch and from around the PTO idler pulley.
• Route the new belt as shown in Figure !4, around the deck pulleys, idler pulley and electric PTO clutch.
• Remount the belt guards removed earlier.
Electric
PTO Idler Pulley
on tractor)
Deck Idler Pulley
m
Deck belt (Bottom)
PTO belt (Top)
Right Hand
Double Pulley
(beneath
belt guard)
Left Hand
Double Pulley
Center Pulley
Self=TappingScrews
NOTE: Lefthand beltcover notshownfor
clarity,
46-inchdeckshown.
Figure 15
46-inch decks
• Lower the deck by moving the lift lever into the bottom notch on the right fender.
• Remove the belt guards by removing the self-tapping screws that fasten them to the deck.
• Grasp the PTO idler pulley bracket and pivot it toward the discharge chute to relieve tension on the belt.
• Remove the deck belt from the electric PTO clutch and from around the PTO idler pu_ey.
• Remove and discard old belt.
• Route the new belt(s) as shown in Figure 15. OEM belt part numbers shown below.
• Remount the belt guards removed earlier,
42-Inch Deck
46-Inch Deck
PTO (Top) Belt
754-04.72
754-0476
Bottom Belt
N)A
754-0349
CHANGING
THE
TRANSMISSION
DRIVE
BELT(S)
All belts on your tractor are subject to wear and should be replaced if any signs of cracking, shredding or
rotting are present.
IMPORTANT:
The V-belts found on your tractor are specially designed to engage and disengage safely, A
substitute (non-OEM) V-belt can be dangerous by not disengaging completely, For a proper working machine,
use factory approved belts,
To change or replace the drive belt(s) on your tractor, proceed as follows:
NOTE;
It's recommended
that both drive belts be replaced at the same time,
• Remove the cutting deck as instructed earlier in this section.
• After disconnecting the battery cables, remove the battery and battery tray from beneath the seat.
IMPORTANT:
When removing the batter_, disconnect the NEGATIVE
(Black) wire from it's terminal first,
followed by the POSITIVE (Red) wire. ReJnstalt in reverse order.
19

Advertisement

Table of Contents
loading

Table of Contents