Table of Contents
Advertisement
LIFT LEVER
Hflflfiflr
The lift lever is used to change the operating position
(height) of the cutting deck. To operate, move the
lever to the left, then place in the notch best suited
for your application.
ELECTRIC
PTO
(POWER
TAKE-OFF)
KNOB
To engage the power to the cutting
deck or other attachments on units
equipped with an electric PTO, pull
outward on the PTO knob. Push the
PTO knob inward to disengage the
power to the attachments,
NOTE:
The PTO knob must be in the disengaged
(OFF)
position
when
starting
the engine,
when
shifting into reverse and if the operator leaves the
seat.
AUTODRIVE'-PEDAL
The AutoDrive _ pedal is located
below the brake
pedal on the right front side of the tractor along the
running board. Depress
the AutoDrive "=pedal with
your right foot when the tractor shift lever is in either
forward or reverse to cause the tractor to move.
Ground speed is also controlled with the AutoDrive
TM
pedal. The further down the pedal is depressed, the
faster the tractor will travel. The pedal will return to
its original position when it's not depressed.
IMPORTANT:
Always
set
the
parking
brake
when leaving the tractor unattended.
BRAKE
PEDAL
The brake pedal is located on the right front side of
the tractor above
the AutoDrive,"
pedal along the
running board. The brake pedal can be used for
sudden stops or setting the parking brake.
NOTE:
The brake pedal must be fully depressed to
activate the safety interlock switch when starting the
tractor.
PARKING
BRAKE
BUTTON
To set the parking brake, fully depress
the brake pedal and push the parking
brake button in. Hold the button in
while taking your foot off the brake
pedal.
Both the parking
button and
the
brake
pedal
will
then
stay
depressed.
To release
the parking
brake,
depress
the
brake
pedal
slightly. The parking brake button will
then return to its original position.
NOTE:
The parking
brake
must
be set if the
operator leaves the seat with the engine running or
the engine will automatically
shut off.
IMPORTANT:
Always
set
the
parking
brake
when leaving the tractor unattended.
SHIFT LEVER
The shift lever is located
on the
left
side
of the
fender
and
has
three
positions,
FORWARD,
NEUTRAL and REVERSE.
The brake pedal must be
depressed
and the tractor
must
not
be
in
motion
when
the
moving
shift
lever.
IMPORTANT:
Never
force the shift lever. Doing
so may result in serious
damage
to
the
tractor's
transmission.
Shift
Knob
10
Advertisement
Table of Contents
