Sharp AQUOS LC-40LE810UN Operation Manual page 50

Using a PC
[] PC control of the iV
• Attach an RS-232C cable cross-type (commercially
available) to the supplied Din/D-Sub RS-232C for the
connections.
o This operation system should be used by a person who is
accustomed to using computers.
[] Communication conditions
Set the RS-232C communication settings on the PC to
match the TV's communication conditions.
The TV's communication settings are as follows:
9,600 bps
8 bits
None
1 bit
None
[] Communication procedure
Send the control commands from the PC via the RS-
232C connector.
The TV operates according to the received command
and sends a response message to the PC.
Do not send multiple commands at the same time.
Wait until the PC receives the OK response before
sending the next command.
[] Command format
Eight ASCII codes ÷ CR
021031041pl IP2 P3IP4141
\ ......................................................... / / \ ........................................................... ]............................................... / /
Command 4-digits Parameter 4-digits Return code
Command 4-digits: Command. The text of four characters.
Parameter 4-digits: Parameter 0-9, x, blank, ?
[] Parameter
Input the parameter values, aligning left, and fill with
blank(s) for the remainder. (Be sure that 4 values are
input for the parameter.)
When the input parameter is not within an adjustable
range, "ERR" returns. (Refer to "Response code format".)
Any numerical value can replace the "x" on the table.
When "?" is input for some
commands, the
present setting
value responds.
[] Response code format
Normal response Problem response (communication
error or incorrect command)
Return code (0DH)
[] Command table
Commands not indicated here are not guaranteed to operate.
CONTROL ITEM COMMAND PARAMETER
POWER ON COMMAND SETTING RiSiPiW 0! ! ! Off
Return code (0DH)
i i i 1 i i i On
POWERSE_MG PiOiWiR 0l l i P .... Off
iii liii P ....On
_NPUTSELECT_ON _,GGLE_ITIGID xi- - _ogg_e/
I iTiViD Oi
I Ei A Ei V Ei D * i ] - Input terminal number (1 7)
AV MODE SELECTION AiViMiD *i i i 0:(Toggle),1: STANDARD. 2:MOVIE, 3:GAME.
i i i i i i 4: USER, 5: DYNAMIC (Fixed), 6: DYNAMIC. 7: PC.
i i i i i i 8: x.v. Color. 100: AUTO
VOLUME V l O l L I M * i * i l Volume (eL60)
POSITION H-POSITION H El P EIO El S * i * i * i
V POSITION V j P j O j S * j * j * j
CLOCK Ci L iC iK * i * i * i Only PCmode.(0 180)
PHASE Pi Nj SjE _j _j * j OrU PC mode. (04o)
VIEW MODE WiliDiE *i i i 0: (Toggle) [AV], 1 : Side Ba/[AV), 2: S.St/eteh [AV]
i i i i i i 3: Zoom [AV], 4: Stretch [AV}, 5: No/rnal [PC]
i i i i i i 6: Zoom [PC], 7: Stletcb [PC],
i i i i i i 8: Dot by Dot [PC) [AV], 9: Full Screen [AV]
j j j j j j 10: Auto [Netflb,,], 11: Odginal [NetF,ix]
MUTE MjUjTjE *j j j 0: (Tcxjgle), 1 : On. 2: Off
SURROUND A j C j S j U * j j j 0:(Toggb), 1: On. 2: Off
AMD,O SELEOTiOM AiOiMiA xi i i _oggle)
SLEEPTIIVlER OjFjTjM *j j j 0:Off, IOFFTIMER 30MIN,2OFFTIMER 60MIN,
ii i ii i
8:OFFTIMER 90MIN,4:OFFTIMER 120MIN
CHANNEL DIRECT DIGICIM * i * i * i The channel numbe_ of TV
CHANNEL i i i i i i {1 135)
(ANALOG) I I I I I I
DIRECT DIAi 2 1P * i* i* i* (01009999)
CMAMNEL DiOi2iU *
(DIGITAL) i i i
j'j*j (1999)
DiOi2iL *i*i*i {0999)
iii iii
DiCil i 1 *i*i*i* (06383)
CHUP CIHIUIP xl i i TllechannelnumberofTV+l
CMDOWN OjNjDjW xjjj Theohanne_numb_ro_V 1
CO CiLiCiP xi i i {Toggle)
CONTROL CONTENTS
The Power On command reiected.
The Power On command accepted.
It shifts to standby.
Power On
It input switches by the toggle. (It is the same as an input chaoge key)
It input switches to TV. (A channel remains as it is. (Last memory))
It input switches to INPUT1 _INPUT7.
Although it carl choose now. it is toggle operation in inside.
The screen position variable ranges depend on the View Mode or the
signal type. The ranges can be seen on the position setting screen.
0: ARhough it can choose now. it is toggle operation in inside.
1 : Only available when 4:3 signal is being input.
5, 6: Only available when 4:3 signal is being input.
8: [PC) Availabb except when UXGA is being input.
{AV] Only availabb when 1080Vp is being input.
9: Only available when 720p is being input.
An input change is included if it is not TV dispby.
in Aic 2-690h is effective.
In Cobb. 1 135chiseffect_ve.
DIGITAL Air (Two Part numbers, 2 digit plus 2 digit)
DIGITAL Cable {Two Part numbers, 3 digit plus 3 digit)
F/_nt half d DIGITAL CABLE CHANNEL NO. (Designate major channel)
DIGITAL Cable {Two Part numbers, 3 digit plus 3 digit)
Rear half of DIGITAL CABLE CHANNEL NO. (Designate minor channel)
DIGITAL Cable (One Part numbers, 5 digit, less than 10,000)
DIGITAL Cable (One Part numbers, 5 digit, more than 10.000)
if it is not TV display, it will input switch to _/. (same function as CHA)
if it is not TV display, it will input switch to _/. (same function as CHV)
Toggle operation of a closed caption.
If an underbar (_)appears in the parameter column, enter a space.
= If an asterisk (*)appears, enter a value in the range indicated in brackets under CONTROL CONTENTS.
= Any numerical value can replace the "x" on the table.
@- 49