Checking The Water Dispenser Line - Samsung RF266 User Manual

CHECKING THE WATER DISPENSER LiNE
A water dispenser is just one of the helpful features on your new Samsung Refrigerator. To help promote better
health, the Samsung water filter removes unwanted particles from your water. However, it does not sterilize or
destroy microorganisms. You may need to purchase a water purifying system to do that.
in order for the ice maker to operate properly, a water pressure of 20-125 psi (pound per square inch) is
required.
Under normal conditions, a 170 cc (5.75 oz.) paper cup can be filled in 10 seconds.
If the Refrigerator is installed in an area with tow water pressure (below 20psi), you can install a booster pump to
compensate for the low pressure.
Make sure the water storage tank inside the Refrigerator is properly filled. To do this, press the water dispenser
lever until the water runs from the water outlet.
Water line installation kits are available at extra cost from your dealer. We recommend usng a water supply kit that
contains copper tubing.
Connecting to the water supply line
1. First, shut off the main water supply line and turn the ice-maker off.
2. Locate the nearest cold, drinking water line.
3. After connecting the water supply to the water filter, turn your main water supply back on and flush at
least a gallon of water (2_-3 minutes) into a bucket to clear and prime the water filter. Otherwise, water
may drip after dispensing water.
Shut off valve
Q old water line
Pipe clamp
Water line installation kit
\
SettingUp 17