SETTING UP THE REFRIGERATOR
Now that you have your new Refrigerator installed and in place, you are ready to set up and enjoy the features and
functions of the appliance.
By completing the following steps, your Refrigerator should be fully operational.
1. Placethe Refrigerator in an appropriate location
with reasonable clearance between the wall and
the Refrigerator. Refer to installation instructions in
this manual.
2. Once the Refrigerator is plugged in, make sure the
interior light comes on when you open the doors.
3. Setthe Temperature control to the coldest
temperature and wait for an hour. The Freezerwill
get slightly chilled and the motor will run smoothly.
4. After powering the Refrigerator, it will take a few
hours to reach the appropriate temperature. You
can store food and drinks in the Refrigerator once
the temperature is sufficiently cool.
Check the accessory list below.
Hex
wrenc
_
(DA80-00002C)
Water filter
(DA29-00003B)
Fastener
(DA60-00143B)
Compression
Compression
fitting
nut
(DA62-OO305A)
(DA74-OOO70B)
Washer
(DA80-00002C)
COMPONENTS
FOR HANDLE
ASSEMBLY
[ 3-DOOR
TYPE ]
HOW TO ASSEMBLE
THE HANDLE
Fridge door handle assembly
i i
i
_!_i_i_i_i;,!!_i;i;i,,!_i,,!;;;,,,;;,,,_,_
ii i i i I
i
iiiiiiiiiiiii Ji! !i iiiiiiiiiiiiii!i i i i i ii ii i ii i i i i i i i !
To best conceal the connection
points : Assemble the handles
with the mounting screws facing
each other.
Byusing Phillips s crewdriver, fix
thescrew andthen
put
thehandle
onthefixer.(Optional)
_By
usingL-wrench, F ixthe screwwiththe Longerpartof it and
thenfullytightenup withthe Shorterpart.
i @i
Setting Up _9