Checking The Water Dispenser Line; Installing The Water Line - Samsung RSG309 Series User Manual

CHECKING THE WATER DISPENSER
LINE
a water dispenser is one of the helpful features on
your new Samsung Refrigerator. To help promote
better health, the Samsung water filter removes
unwanted particles from your water. However, it does
not sterilize or destroy microorganisms. You may need
to purchase a water purifying system to do that.
In order for the ice maker to operate properly, a water
pressure of 20~125 psi (pound per square inch) is
required. Under normal conditions, a 170 cc (5.75 oz.)
paper cup can be filled in 10 seconds.
If the Refrigerator is installed in an area with low water
pressure (below 20psi), you can install a booster pump
to compensate for the low pressure.
Make sure the water storage tank inside the
Refrigerator is properly filled. To do this, press the
water dispenser lever until the water runs from the
water outlet.
Water line installation kits are available at extra
cost from your dealer. We recommend using a
water supply kit that contains copper tubing.
Connecting to the water supply line
1. First, shut off the main water supply line and turn
the ice-maker off.
2. Locate the nearest cold, drinking water line.
3. After connecting the water supply with water filter,
turn on water supply and Flush 3 gallons through
filter before use (flush approximately 6 minutes).
Cold water
line
Pipe clamp
Shut off valve

INSTALLING THE WATER LINE

Connecting the water line to the Refrigerator.
There are several items that you need to purchase to
complete this connection. You may find these items
10_ setting up
sold as a kit at your local hardware store.
1. Slip the compression nut (A) through the supplied
2. Tighten the compression nut (A) onto the 1/4"
-
-
Water line installation
kit
3. Tighten the compression nut (B) onto the
4. Turn water on and check for any leakage.
1/4" compression nut
copper tubing
Refrigerator
Plastic tubing
(A) (Supplied)
Ferrule (Not
supplied)
Copper tubing
or
(Not supplied)
Household water supply line
plastic tubing (A).
compression fitting.
If you are using copper tubing, slip the
compression nut (B) (not included) and ferrule
(not included) on copper tubing (not included) as
shown.
If you are using plastic tubing (B), insert the
molded end(Bulb) of the plastic tubing (B) into the
compression fitting.
Do not use without the molded end(Bulb) of
the plastic tubing (B).
CAUTION
compression fitting. Do not over-tighten the
compression nut (B).
Only connect the water line to a drinkable
water source.
If you have to repair or disassemble the water
line, cut off 1/4" of the plastic tubing to make
sure you get a snug, leak-free connection.
plastic tubing
ferrule
Compression
nut (A) (1/4")
(Supplied)
Compression
fitting (Supplied)
Molded
end(Bulb)
Compression
nut (B) (1/4") (Not
supplied)
Plastic tubing (B)
(Not supplied)