Table of Contents
Advertisement
Programming
the Remote to Operate
Other Components
Tile universal remote control can be programmed
to operate
most brands of
remote controllable
VC, R s, satellite receivers and cable boxes, Tile remote is
already programmed
to operate most RCA, GE and Proscan TVs, VC, R s, l)X,q)
players, laserdisc plwers
and satellite receivers.
Find Out If You Need to Program the Remote
To determine
whether
the universal remote needs to be programmed,
mm a
component
ON, sud3 as a VCR, point the remote at the VCR, and press the
VCR2 button. Tilen press ON-OFF
or channel up or channel down to see [f
the VCR responds
to the remote commands.
If not, the remote needs to be
programmed.
You'll use these buttons
when you program
the remote to operate another component.
The remote may not operate all models of
all brands.
How to Program the Remote
Ti_ere are two x_-ays to program
the remote controh automatic
code search and
direct ent W, rnstru_ions
for both wws
follow.
Tostopthe automaticcede search without
progr_mmin 9 any _ornponents, p ress and hold CLEAR
until the_ight on the rcmo{_toms off,
Using Automatic
Code
Search
1,
Tam on the component
you want the remote to operate
(VCR, DVD Player,
etc.)
,)
Press and hold the component
burton on the remote control that
corresponds
to the component
you want the remote to operate
(VCR2,
DVI), etc.). :ql[le you hold down the component
button, press and hold
ON°OFF
(when the red light on the remote turns on, release both buttons).
3,
Press PLAY
(the
red light on the remote, located below the ON-OFF
bulton,
starts flashing),
Tile remote is seareh_ng the first set of component
codes (there are 20 sets
of codes). If the component
you x_-ant to operate doesn't mm off
automatically
after 5 seconds, press PlAY again (the red light starts flashing
again as %e remote seare]les through
the next set of codes).
Continue pressing PLAY onfil the component
rams off,
Note: _ the co¢_g_onent doe,s'n "tturn oy_'after you '*_'e preaxed the PlAY
button 20 times, the co¢_g_on_nt can't !mprogrammed,
4,
Press RE'_RSE, wait 2 seconds. Repeat fl_Js step until the component
turns
back on.
5,
To finish, press and hold tim STOP button until the red light on the remote
turns off.
18
Advertisement
Table of Contents
