Table of Contents
Advertisement
CONNECTING
A COMPATIBLE
D'VHS
VCR
The DSS® receiver can send a digital signal to a compatible D-VHS
VCR. The D-VHS VCR can then record.and playback recordings
through the DSS® receiver, if you have a D-VHS VCR you must
connect both devices so they can send and receive digital signals.
1) Connect a digital audio/video (DAV) cable as shown.
2)
Connect RCA type audio/video cables as shown.
The D-VHS VCR and DSS ® receiver communicate through the DAV
cable. It is not necessa_ to connect the VCR controller or enter
the VCR type described earlier in this section.
@ @ @
I
D-VHS
m_
r .._-_.
,,_--I
I
R
l
'_0_0 GiFTAllOi@OUT
INTERACTIVE
SETUP
r
if you self-installed your satellite dish antenna, you may have
already used the interactive setup to find the dish pointing
coordinates, acquire and fine-tune the signal, and run a system
test.
If y_u need to run the interactive
setup again, select Options
from the Main menu, then select Interactive Setup.
If you just want to check your dish pointing coordinates, or run
the signal strength meter, select Dish Pointing from the Main
menu.
ORDERING
DSS
PROGRAMMING
After you have installed your system, you should contact the
service providers, DIRECTV and USSBto receive DSS ®
programming.
Programming with DIRECTV:
Call 1-800-347-3288
Programming with USSB:
Call 1-800-204-USSB
When you order programming,
you need to know your Access
Card number.
To get the number,
select Options from the Main
menu, then System Options, and
then select System Test.
Wait for the system to run all of
it's tests. The Access Card number
is displayed
at the end of the
system test.
Write the Access Card number
in
the space below
for easy
reference:
18
Advertisement
Table of Contents
