Table of Contents
Advertisement
Connections
and
Setup
Using Direct Entry
1.
Turn on the component
you want the remote to operate (the red light on the remote turns
on).
2.
Look up the brand and code number(s)
for the component
on the code list on the following
pages.
3.
Press and hold the component
button that corresponds
to the component
you want the remote
to operate
(VCR, RCA DVD, etc.).
4.
Enter the code from the code list. When you begin entering numbers,
the red light on the
remote rams ofT. When the last number
is entered, the red light turns back on. If the incorrect
code is entered, the red light will flash.
5.
Release the component
button. The red light on the remote turns off.
6.
Press ON-OFF
to see if the component
responds
to the remote commands.
If it doesn't,
try
pressing the component
button and then ON-OFF
again.
6.
If you get no response,
repeat these steps using the next code listed for your brand, until the
component
responds
to the remote commands.
How To Use the Remote Control After You've Programmed
It
Once the remote control has been programmed
successfully,
you're ready to use it to operate
other components.
1.
Press one of the video source buttons to select a component
(VIDEO or RGB) to operate.
2.
Press the component
button (MONITOR, VCR, DVD, AUX, or HD RCVR) to use the Transport
buttons
(REVERSE, PLAY, FORWARD, STOP, PAUSE, and RECORD) to operate the component.
3.
Press ON-OFF
to turn the component
on or off.
NOTE: If you keep pressing buttons and nothing happens, you may have the wrong video
source or wrong component selected. You must select the correct video source and the
component button that matches the component you want to operate.
Chapter
1
17
Advertisement
Table of Contents
