Using Direct Entry; How To Use The Remote After You've Programmed It; Using The Input Button - RCA D52W23 User Manual

Important
You must continue pressing the device
button while you enter the code.
Let's say you have a Zenith DVD player. To
program the universal remote to operate
the DVD player, you would:
Press and hold the DVD button while you
enter the first code listed for Zenith in the
DVD Codes column.
Release the DVD button. Press ON•OFF to
see if the DVD player responds. If it doesn't,
follow the same steps, but enter the second
code for Zenith DVD players instead of the
first.
Device Buttons
DVD
AUX•HD TV
Note
Some of the remote's buttons might operate
differently for other devices, especially when
you're using another device's menu system.
Chapter 2
If the device you want to control does turn off:
1. Press and release REVERSE, then wait 2 seconds. Repeat this step until the
device turns back ON.
2. To finish, press and hold STOP until the indicator on the remote turns off. A
code that controls your device has been saved to that remote button.

Using Direct Entry

1. Turn on the device to be programmed.
2. Look up the brand and code number(s) for the device on the code list in this
section.
3. Press and hold the device button you want to program on the remote.
4. Enter the code from the remote control code list on the following pages. If the
indicator flashes, you have either entered an invalid code or the button isn't
programmable.
5. Release the device button. Point the remote at the device. Keep the remote
pointed at the device until the end of this step.
Press ON•OFF to see if the device responds to the command. If it doesn't, try
pressing the device button and then ON•OFF again.
• If you get no response, repeat these steps using the next code listed for your
brand, until the device responds to the remote commands.
• If you try all the codes for your device brand and none work, try the
automatic code search method. If automatic code search doesn't find the code,
the remote is not compatible with your device.

How to Use the Remote After You've Programmed It

Because this universal remote can control several different devices (HD Monitor, DVD,
VCR, satellite receiver, etc.) it uses operational modes triggered by the device buttons.
ON•OFF
For example, if you want the remote to control the HD Monitor, you would press the
TV button to put the remote into TV mode before you could control the HD Monitor.
1. Press the appropriate device button (DVD, AUX•HD. or TV) to set the remote
to control the device.
2. Press ON•OFF to turn the device ON or OFF.
3. Use the remote buttons that apply to that device.
Notes:
•
•

Using the INPUT Button

Use the INPUT button to scroll through the available inputs and view devices you
have connected to the HD Monitor.
1. Press TV to place the remote in TV mode. Make sure the device you want to
view is turned ON.
2. Press INPUT to tune to an available input channel.
3. To return to the channel you were previously watching on HD Monitor, press
CH+ or CH- button.
Using the Remote Control
The remote may not be compatible with all brands and models of
devices. It also may not operate all functions of the remote that came
with your device.
If you keep pressing buttons and nothing happens, the remote is probably in
the wrong mode. You must press the device button that matches the device
you want to operate (i.e., if you want to operate the DVD player, press DVD
on the remote control to put the remote in DVD mode.)
does does turn off:
19