GE VG2050 User Manual page 6

Step 1: What's in the Box?
The following items come pecked in the box:
VCR
Remote control
RF coaxial cable
AAA Batteries
Step 2: Install Batteries in the VCR's
Remote Control
Follow these steps whenever installing or changing the batteries
in the VCR's remote control:
1,
2.
Remove the cover of the battery compartment on the rear of
the remote control.
Place the batteries into the compartment matching the
positive (+) and negative (-) ends of each battery to the
diagram inside the compartment.
3. Replace the cove_
Step 3: Connect the VCR to a TV
If you connect the VCR to a home antenna or cable system and
then to a TV, use the VCR's ANT. IN and RF OUT jacks for a good
signal (as shown in the diagram to the right).
If you have a TV with AUDIONIDEO jacks, use these jacks for a
better connection. Refer to the Connections section for additional
setup options.
Step 4: Plug in the VCR
Your VCR's power cord has a plastic band strung through the
blades. Remove plastic band before plugging the cord into
the power outlet. To remove band, cut with a pair of scissors
and pull it free of the blades. Once the plastic is removed, match
the wide blade of the power cord to the wide slot in the AC
outlet. Be sure to insert the plug completely.
VCR
CABLE, CABLEBOX,ORANTENNA "_
4