Table of Contents
Advertisement
Things
to Know Before
Connecting
Components
Protect
Your Components
from Power
Surges
Connect all components
before plugging
any
power cords into the wall outlet.
Always turn off the TV and other components
before you connect or disconnect
any cables.
Position
Cables
Correctly
to Avoid
Audio
Hum or Interference
Insert all cable plugs firmly
into their jacks.
Place the audio/video
cables to the sides of the
TV's back panel instead of straight down the
middle after you connect your components.
Try not to coil any twin-lead
cables and keep
them away from the audio/video
cables as much
as possible.
Make sure all antennas and cables are properly
grounded.
Refer to the Safety "13pssheet packed
with your unit.
Protect
Your Components
from
Overheating
Do not block ventilation
holes in any of the
components.
Arrange the components
so that air
can circulate freely.
Do not stack components.
Allow adequate ventilation
when placing your
components
in a stand.
Place an amplifier
or satellite
receiver on the top
shelf of the stand so heated air rising from it will
not flow around other components.
V
V
¥
V
¥
6 CONNECTIONS I
V
37
Advertisement
Table of Contents
