Table of Contents
Advertisement
Fi t'TimeO t W
The steps below will help you get your TV connected
and
working quickly.
1.
Unpack TV and accessories.
Shown here are the accessories that came packed with your TV.
Remote Control
Four AAA Batteries for
Remote
Power Cord
2.
Install batteries
in remote control.
Details are on page 6.
3.
Connect
antenna or cable-TV
system.
Most antenna or cable-TV systems can be connected as
show here.
Back
of "13/
• Details for connecting a home antenna to your 'IV are on
page 26.
• Details for connecting a cable-TV system to your TV
are on pages 27.
• Details for connecting a VCR to your TV are on
pages 30-31.
4.
Attach power cord.
'First attach the flat end of the power cord completely into the
connector on the back of your TV, and then plug the other
end into a wall outlet.
5. Turn on TV, adjust the volume, and select a channel.
• Press the TVbutton on the
[_t
rv
remote to turn on the TV.
a,,tto,
When using the remote,
Number'--
Buttons
remember to point it at the ,a.no,_
_
!_
_"
VOLUME
front of the TV.
_|
a_tto,_
• Press the VOLUME up or
_-_---I
down button to adjust the
_:'-o [
volume to a desired level.
• Press the CHANNEL up or
down button to select a chanael in memory. You can also
press two number buttons to select a channel. To select a 3-
digit cable channel (up to channel 128), press and hold
number button 1 until 1-- appears on the screen. Then press
the other two numbers. Channels 2-13 were programmed
into the channel memory for you at the factory, so pressing
CHANNEL up or down stops at these channels only. When
you start the AutoProgrammmg
feature (described below),
your set automatically scans through all channels and place
only the active channels for ,tour area into its channel
memory.
• Details about using the remote are on page 6-9.
6.
AutoProgram
the TV's channel
memory.
To start the TV autoprogramming
itself, press the MENU
button repeatedly to select SETUP MENU and then press + to
display the setup functions. Repeatedly press MENU again
to select the AUTOPROGRAM function, and then press +.
Details are on page 2 I.
SetAlarm
Mute
Chart L abel
Video Menu
Parental Ctr!: Off
AudioMentt
ChartCt_;. N ormal
t
.qlll|o_ell[Olol_l|l
You can also add and erase channels from memory as desired.
Press MENU repeatedly to select the SETUP MENU, then
press + to display the setup functions.
Press MENU repeatedly
to select (highlight)
the CHAN MEM
function.
Select the desired channel
number
by pressing
the
CHANNEL
up or down button or by pressing
the two
corresponding
number buttons.
Then press + to add a channel, or press - to erase a channel.
Details are on page 21.
Advertisement
Table of Contents
