Table of Contents
Advertisement
No sound,
picture
okay
Maybe sound is muted.
Try pressing volume up button
to restore sound.
Maybe speakers are turned off.
Check the Audio Output and Speakers control panel in the Audio
menu.
If using an S-VHS component,
remember
to also connect the component's
L and R AUDIO OUT jacks to the TV's L and R
INPUT jacks.
Can't
select
certain
channel
Channel may be blocked
or not approved
in the Parental Controls menu.
If using a VCR, check to make sure the TV/VCR switch on the VCR is in the correct position.
Noisy stereo reception
May be a weak station.
Use SOUND button
to change to mono mode instead of stereo.
No picture, no sound but TV is on
Maybe the cable/air function
is set to the wrong position.
Maybe a vacant channel is tuned.
If watching
VCR (connected
only through
antenna
input),
make sure TV is tuned to channel 3 or 4 - same as CH3/4
switch on VCR. Also check to make sure TV/VCR switch on VCR is in the correct position.
Sound okay, picture poor
Check antenna connections,
Try adjusting
sharpness function
to improve weak signals.
Black box appears on the screen
Captioning
may be turned on. Check the Closed-Caption
Display control
panel in the Channel menu.
G-LINK Cable not working
Check to make sure the wands are positioned
correctly,
GUIDE Plus+ Gold System control
of cable box is slower than direct control of the box itself. Keep this in mind when
changing
channels.
Incorrect GUIDE Plus+ Gold System channel map
The guide may get out of sync with the cable provider. Use setup to change the zip code to 99999. Turn the TV off for
ten minutes.
Use setup again to change the zip code to the correct value. Be sure to select the correct lineup if asked.
54
Advertisement
Table of Contents
