Table of Contents
Advertisement
Editing
Features
(continued)
Titler (con_nued)
Creating
a Title
1. Attach a power source to the
camcorder.
Press and hold the small
red button on the CAMERA/OFF/VCR
switch while you slide it to CAMERA.
2. Press TITLER to display the titler
graphics in the viewfinder or on the
LCD monitor. A flashing cursor
appears.
3. Press EDIT-ADVto move the flashing
cursor to the place where you want to
begin your title.
4. Select the first character for your title
by pressing the + or - button until the
character you want appears in the
viewfinder or on the LCD monitor.
See the chart below for the characters
available.
5. After you have selected the first
character,
press EDIT-ADV
to move
the flashing
cursor to the place where
you want the next character
to appear.
6. Repeat
steps 4 and 5 until you have
completed
the title.
7. When you are finished,
press TITLER
to store the title and remove the title
graphics
from the viewfinder
or LCD
monitor.
Remember:
Be sure to remove the titler
graphics from the viewfinder or LCD
monitor for normal recording.
Correcting
an Error
1. Press TITLER to display the titler
3.
graphics
in the viewfinder
or on the
LCD monitor.
2.
Press EDIT-ADV
to move the flashing
cursor over the character
you want to
correct.
Press the + or - button
until the
correct character
appears.
Note: If you want to delete a character,
press + or - until the blank space appears.
Chart
of Characters
in Titler's
Register
AB
C
D
E F
GH
IJ
KL
M
N
O PQ
R
S T U
VWXYZ
01
23456789?
'
/,
-
; :
< >
! (BLANK)
39
Advertisement
Table of Contents
