Table of Contents
Advertisement
PIP (PICTURE-IN-PICTURE)
OPERATION
The PIP (picture-in-picture)
feature
lets you display a second, smaller
picture on top of the main picture.
Your TV is equipped
with a single tuner that tunes to cable or off-air
television
signals. The PIP feature
on your TV requires a second video
source, like a VCR or satellite
receiver to supply the second picture to the
screen. The PIP feature
also requires connecting
the second video source
to the TV with audiolvideo
cables.
PIP Buttons
There are seven remote buttons
that control the way the PIP window
works:
PIP Brings up the PIP window.
Press PIP again to remove the window.
When PIP Caption Display-Alternate
with PIP has been selected, will
display captioning
in the PIP window.
MOVE
buttons
Let you
move the PIP window
to different
areas of the
screen.
SWAP Switches, or "swaps,"
the video from the PIP window
with the
main picture.
Using the PIP Feature
While you may use PIP in different
ways, this basic PIP scenario should
get you started. While watching
the TV, follow
these steps to use your
VCR to supply the picture for PIP.
I.
Press the PIP button
on the remote.
The PIP window
appears on the
screen.
2.
Turn on theVCR.
3.
4.
S.
Press the TV button,
then press INPUT until you see the VCR signal
displayed in the PIP window.
The PIP window
should display the
channel that you have the VCR tuned to.
To change the program
in the PIP window,
you need to change the
channel on the VCR because that is the signal source for the PIP
picture. Press the VCR button
on the remote to get into VCR mode,
then change channels.
Use the channel up and down buttons along with the SWAP button
and MOVE arrows to adjust the two pictures.
_OW£?, VCR1 SAT*CAbLE T_
REW
PLAY
FF
REC
STOP
_AUSE
DISPLAY
S_+P
0
c.A+ 0
MUTE
CHA"_
PREVCH
i© 2© +O
4© +© +©
7© +O gO
IP6T
00
AN'_NA
CLEAR
_b
_
RESET
MOVE buttons
--
PIP buttons--
A typical use of SWAP is to scan through
channels in the PIP window,
and when
you find a channel you like, press SWAP
to display that channel in the main
picture, sending the current
channel to
the PIP window.
You must change the mode between the
TV and VCR after every SWAR
]
36
Advertisement
Table of Contents
