Table of Contents
Advertisement
Using the Remote to Control a Device
Once the remote has been programmed
successfully, you are ready to
use it to control your devices.
To operate the device:
1.
Press the device button
(TV, VCR1, VCR2*LD, BAT*CABLE, or AUDIO)
to set the remote to control the device.
2.
Press POWER to turn the device on or off.
3.
Use the remote buttons that apply to that device.
MODES
OF OPERATION
Because this universal remote can control several different
components
(Laserdisc player, VCR, Cable Box, etc.) it uses operational
modes
triggered
by the component
buttons.
For example if you want the
remote to control the TV, you would press the TV button
to put the
remote into TV mode before you could control the TV.
FRONT
PAN EL
If you cannot locate your remote you can use the front panel of your TV
to operate
many of the TV's features.
MENU
Brings up the Main menu. When in the menu system, it selects
highlighted
items. Also returns you to the previous menu.
CHv
Scans down through
the current channel list. In the menu system,
it points down to items and adjusts menu controls.
CHA
Scans up through
the channel list. In the menu system, it points
up to items and adjusts menu controls.
VOL - Decreases the volume. When in the menu system, VOL - is used
to point left to items and adjust menu controls.
VOL + Increases the volume. When in the menu system, VOL + is used
to point right to items and adjust menu controls.
POWER Turns the TV on and off.
ENU
CHV
CHA
VOL--
VOL +
POWER
I
The front panel above shows a typical
button layout. The exact look of the
buttons
may be different
from those on
the front of your TV.
The Front Panel Block feature disables all
front panel buttons
if Parental Controls
are locked. For more information,
see
Parental Control, in the Menus and
Features section.
23
Advertisement
Table of Contents
