Table of Contents
Advertisement
PROGRAMMING
TH E REMOTE
The universal remote can be programmed
to control
most brands of
remote controllable
VCRs, satellite
receivers and cable boxes. The
remote is already programmed
to control
most RCA, GE and PROSCAN
TVs, VCRs, Laserdisc players and Satellite
Receivers.
TESTING
THE REMOTE
To determine
whether
the universal
remote needs to be programmed,
turn a device on, such as a VCR, point the remote at the VCR, and press
the VCR1 button.
Then press POWER or CHA (channel up) or CHV
(channel down) to see if the VCR responds to the remote commands.
If
not, the remote needs to be programmed.
Programming
the Remote to Control
a VCR, Laserdisc
player, Satellite
Receiver or Cable Box
Follow these steps to program
your universal remote to control
a VCR,
Laserdisc player, Satellite
Receiver or Cable Box:
1.
Turn on the component
to be programmed.
2.
Look up the brand and code number(s)
for the component
on the
code list on the last page of this section, Using the Remote.
3.
Press and hold the button
on the remote you want to program.
4.
Enter the code from the code list.
5,
6,
Release button,
and then press POWER to see if the component
responds to the remote commands.
If it doesn't, try pressing the
component
button
and then POWER again.
If you get no response, repeat these steps using the next code listed
for your brand, until the component
responds to the remote
commands.
Programming
the Remote to Control
an RCA Audio Device:
Your remote controls only RCA audio equipment
such as an audio
receiver or amplifier--it
does not control
other brands of audio
equipment.
Also, the remote may need to be programmed
for your
equipment.
This remote may not operate
all of the components
listed at
the end of this section. Use the codes at the end of this section or on the
sheet packed in with your remote.
1.
Turn on the component
to be programmed.
2.
Look up your brand and its code number(s)
on the code list.
3.
Press and hold the AUDIO button.
4.
Enter the code from the code list.
5.
Release the AUDIO button
and press POWER or CHA (channel up)
or CHV (channel down) to see if the audio device responds to the
remote codes.
22
20
40 sO 60
70 80 90
80
You'll
use these
buttons
when
you
program
the remote
to control
any
device,
The remote may not operate all
models of all brands,
Advertisement
Table of Contents
