Table of Contents
Advertisement
Negative picture
recorded
No or low sound
during monitor
playback
• Turn off NEG feature.
Set AE dial to A UTO.
• Adjust VOLUME
control on the bottom of LCD monitor.
Streaks in picture
• Adjust tracking with MENU dial. See page 63.
during playback
or
play-pause
Built-in light turns
•
Set LIGHT OFF•A UTO•ON switch to ON or OFF.
on and off
Bright, crystal-
shaped spots
appear in
viewfinder
or on
LCD monitor
Colored bright
spots appear on
LCD monitor
Back of LCD
monitor is hot
Rechargeable
battery runs down
sooner than
expected
•
Sunlight is directly entering the lens.
•
Black spots or bright spots of light (red, green, or blue)
might appear on the LCD monitor.
These spots are not
recorded
on the tape and are not due to a defect in the unit.
•
The light used to illuminate the LCD monitor causes it to be
hot. Close the LCD monitor and turn off the camcorder
to
let it cool down.
•
If battery has not been used for some time, completely
drain
the battery's
power, and recharge
it.
•
Battery run times are measured
when the camcorder
is
recording
continuously.
To check your battery; charge it
completely,
aim the camcorder
at a clock, and record the
clock. When the camcorder
stops recording,
play the last
part of the tape and check the time on the clock.
A one-
hour battery should give you about 60 minutes of recording
time. In practical use, a fully charged battery might not
record for 60 minutes because the battery uses power when
• J you pause and uses extra power when you zoom.
.
.
.-
,
81
Advertisement
Table of Contents
