Table of Contents
Advertisement
Record the Date, Time, and Title Displays
You must install the clock cell and set the date and time (as shown on the previous
pages) before you can select and record the correct date and time. You must create
your title (as described
on pages 46-47) before you can select and record it.
DATE/TIME
Button
Select Date, Time, Date and Time, A UTO DATE, or Title You
Create to Record On Your Tape
1. Attach a power supply and place
•
POWER
switch in CAMERA.
The
power indicator lights.
2. Make sure the AE dial is not set to
°
AUTO to select any mode except
A UTO DATE.
Note: AUTO DATE is selected when the
AE dial is set to AUTO.
3. Repeatedly
press the DATE/TIME
button until the display you want to
record appears on the LCD monitor or
in the viewfinder.
4. Select date, time, date and time,
AUTO DATE, or the title you created.
°
• Date Display:
The date is dis-
played and recorded.
• Time: The time is displayed and
•
, recorded.
Date and Time Display:
The
date and time are displayed and
recorded.
AUTO DATE:
The date is re-
corded for approximately
five '
seconds and then AUTO DATE is
displayed whenever:
• The date has been set or
changed.
• This display mode has just been
selected.
• The tape has been changed or the
tape compartment
opened.
Title: The title you have created is
displayed and recorded.
No display
appears if a I_e has not been created.
No Display:
No display is dis-
played or recorded.
20
Advertisement
Table of Contents
