ProForm CROSSWALK DUAL Owner's Manual page 9

5.
SYMPTOM: THE CROSSWALK DOES NOT INCLINE
a. Stand at the back of the foot railswhile increasingIhe incline. Stand at the front of the foot mils and lean for-
"ward while decreasingthe incline. (See OPERATION AND ADJUSTMENT.)
6. SYMPTOM: THE WALKING BELTSLOWSWHEN WALKEDON
a.
Siliconelubricant mustbe applied to the walking platformbefore the CROSS WALK is used. Lubricantshouldbe
reapplied after every 10 hoursof use, and whenevera decrease in performance is noticed. (See OPERATION
AND ADJUSTMENT for application instructions.) Uni0Sport siliconespray is recommended. CAUTION: ALWAYS
UNPLUG THE POWER CORD WHEN APPLYING LUBRICANT.
b.
C.
If an extensioncord is needed, use only a 14-gauge general-purpose cord of five feet or less in length.
If thewalking belt is overtightened, p erformance may be reduced
and the walking belt permanently damaged. UNPLUGTHE POWER
CORD. Using the allen wrench included,turn bothrear roller
adjustmentbolts counterclockwise 1/4 of a turn. When the tension
of the walking belt is correct, you shouldbe able to lift each side of
the walking belt 2-3 inches;the center of the walking belt should
justtouch the surfaceof the walking platform.Be sure to keep the
walking belt centered. Runthe treadmill for a few minutes.Repeat
until the tensionof the walking belt is correct. Note: Store the allen
wrench in the handy wrench clip. Remove the backing from the
wrench clip and pressthe wrench clip onto one of the endcaps.
2"-3" RearRoller
AdjustmentBolts
Wrench Cli I
7. SYMPTOM: THE WALKING BELT IS OFF-CENTER OR SUPS
a.
b.
If the walking belt has shiftedto the left, firstUNPLUGTHE
POWER CORD. Using the allen wrench included,turn the left rear
roller adjustmentbolt clockwise, and the right bolt counterclock-
wise 1/4 of a turn each. Runthe treadmill for a few minutes.
Repeat as necessaryuntil thewalking belt is centered.
ff the walking belt has shiftedto the right, first UNPLUGTHE
POWER CORD. Using the allen wrench included, turn the left rear
roller adjustment boll counterclockwise, and the right bolt clock-
wise 1/4 of a turn each. Run the treadmill for a few minutes.
Repeat as necessary until the walking belt is centered.
C_
If the walking belt slipswhen walked
on, first
UNPLUGTHE
POWER CORD. Using the allen wrench included,turnboth rear
roller adjustmentboltsclockwise 1/4 of alurn. When the tensionof
the walking belt is correct,you shouldbe able to lift each side of
the walking belt 2-3 inches;the center of the walking belt should
just touchthe walking platform.Be sure to keepthe walking belt
centered. Runthe treadmill for a few minutes.Repeatas necessary
until the tensionof the walking belt iscorrect.
a.
Beforeconverting the CROSSWALK to the stowaway position,lurn the resistancecontrol (see the drawing on page
7) counterclockwise until the canlrol turns freely. Next, unplug Ihe power cord. RemoveIhe lock knob and washer
from Ihe upright and lay the upright and Ihe upper body armson the walking belt. Keep the lock knob and washer in a
securelocation.
.g