Poulan Pro 220 LE Instruction Manual page 6

NOTE: If this saw is to be used for commer-
cial Icggthg, a chain brake is required and shall
not be removed or otherwise disabled to com-
ply with Federal OSHA Regulations for Com-
mercial Legging,
SAFETY NOTICE: Exposure to vibrations
through prolonged use of gasoline powered
hand tools could cause b]oed vesse] or nerve
damage in the fingers, hands, and joints of
people prone to circulation disorders or
abnormal swellings, Prolonged use in cold
weather has been linked to blood vessel
damage in otherwise healthy beop]e, If
symptoms occur such as numbness, pain,
loss of strength, change in skin color or texture,
or loss of feelieg in the fingers, bend& or joints,
discontinue the use of this tool and seek
medical attention. An anti-vibration system
does not guarantee the avc_dance of these
problems. Users who operate power tools on
a continual and regular basis must monitor
closely their physical condition and the
condition of this tool
SPECIAL NOTICE: Your saw is equipped
with a temperaturelimiting muffler and spark
arresting screen which meets the
requirements of California Codes 4442 and
4443. All U.S. forest land and the states of
California, Idaho, Maine, Minnesota, New
Jersey, Oregon, and Washington require by
law that many internal combustion engines
to be equipped with a spark arresting screen.
If you operate a chain saw in a state or locale
where such regulations exist, you are legally
responsible for maintaining the operating
condition of these parts. Failure to do so is
a violation of the law. Refer to the SERVICE
section for maintenance of the spark
arresting screen.
Failureto follow all Safety Rules and Precau-
tions can result in serious injury. If situations
occur which are not covered in this manual,
use care and good judgement. If you need
assistance, contact your authorized service
dealer or call 1-800-554-6723.
STANDARDS: This saw is ]isted by Under-
writer's Laboratories, Inc., and the Canadian
Standards Association in accordance with:
ANSI BI75.1=280g American National
Standard for Powered Tools ~ Gasoline
Powered Chain Saw ~ Safety Requirements
CSA Z62.1-03 Chain Saws ~ Occupational
Health and Safety
CSA Z62.3-96 Chain Saw Kickback Occu-
pational Health and Safety
Protective gloves (not provided) should be
worn during assembly.
ATTACHING THE BAR & CHAIN (If not
already attached)
_]kWARNING:
If received assembled,
repeat all steps to ensure your saw is properly
assembled and all fasteners are secure. Al-
ways wear gloves when handling the chain.
The chain is sharp and can cut you even when
it is not moving!
1. Loosen and remove the chain brake nuts
and the chain brake from the saw.
2. Remove the plastic shipping spacer (if
present).
Location of shipping spacer
a_ Chain Brak_e
Ch Nuts
Bar Tool
3. Turn adjusting screw on bar counter-
clockwise to move the tensioning rack as
far as it will go toward the front of the bar.
(__ Adjusl_g
Tensioning Rac_k _
4. Slide the bar behind clutch drum until bar
stops against clutob drum sprocket.
5. Prepare the chain by checking the proper
direction. Without following the illustration it
is easy to I_ace the chain on the saw in the
wrong direction. Use the illustration of the
chain to determine the proper direction.
Tip of
Bar
DIIRECTION OF ROTATION
Cutters Dept_ Gauge
Drive Links