Jonsered B2126 Operator's Manual page 2

CONTENTS
Contents
Introduction ................... 2
Key to symbols .................. 3
Safety instructions ............... 4
Description ..................... 6
Fuel handling .................... 11
Starting and stopping ............ 12
Using the blower ................. 13
Maintenance .................... 18
Technical data ................... 19
Maintenance, replacement, or repair of the
emission control devices and system may
be performed by any nonroad engine re-
pair establishment or individual
WARNING
The engine exhaust from this product
contains chemicals known to the State
of California to cause cancer, birth
defects or other reproductiveharm.
Note the
following
before
starting:
Jonsered has a policy of continuous prod-
uct development and therefore
reserves the right to modify the design and
appearance of products without prior
noede. Long-term exposure to noise can
result in permanent hearing impairment.
Always use approved hearing protection.
This operator's manual describes in detail
how to use and service the blower and
how to carry out regular maintenance. It
also descdbes which measures should be
taken to achieve maximum safety while
operating the blower, how the safety de-
vices work and how they should be ser-
viced.
Note[ The section of the manual that deals
with safety, must be read and understood
by all persons who come in contact with
the blower.
This operator's manual has been wdnen
for those who need guidance when it
comes to fault tracing, thorough servicing
and carrying out corrective maintenance of
the blower.
There are warning symbols on the blower.
Should any of the warning symbols on the
blower become disfigured or worn, new ones
should be ordered and fitted to the blower as
soon as possible. Note that some of the
warning symbols may be molded in certdln
components of the blower.
The blower is used for blowing away leaves
and other debris on the ground. When op-
erating the blower, the operator must stand
with both feet firmly on the ground.
The Emissions Compliance Period referred
to on the Emissions Compliance label indi-
cates the number of operating hours for
which the engine has been shown to meet
Federal emissions requirements.
Category C 50 hours, B 125 hours, and
A 300 hours.
For reference, please fill out the following
information that will be needed for future
servicing of your blower:
Model Number:
Serial Number:
Purchase Date:
Purchased From:
WARNING:
Under no circum-
stances may the design of the
machine be modified without the
permission of the manufacturer.
Always use genuine accessories.
Non-authorized modifications
and/or accessories can result
in serious personal injury or the
death of the operator or others.
Your warranty may not cover
damage or liability caused by the
use of non-authorized accesso-
ries or replacement parts.
545154659 Rev. 3 7/1/08 English-2