Dry Mode; Fan Mode; Operation - Mitsubishi Mr.Slim MSY-A24NA Operating Instructions Manual

• OPERATING INSTRUCTIONS •
I
0N/0FF
......... Press @ to start the operation.
MODE
Press L_ to select operation mode. Each press
changes mode in the following order:
0
(IFEEL)
,L
O (C_OL)
O (D,_Y)
_,_ (FAN)
_._._J
.......... Press
\A)
or _ to set the
temperature.
Each press raises or lowers the
temperature by
I°F
(1°C).
ON!OFF
Press @ to stop the operation
ooF
. The same setting is selected the next time by simply pressing @.
Operation indicator lamp
The operation indicator lamp shows the operation state of the unit.
Indication Operation state Room temperature
,,. .,,
| | The unit is operating to reach the set About 4°F (2°C) or
more away from set
, , temperature temperature
About 2 to 4°F (1 to
il- 0 The room temperature is approach- 2oc) from set tem-
, ing the set temperature perature
ii Lighted 0 Not lighted
I FEEL mode
The unit selects the operation mode according to the room temperature
when AUTO is selected. When the room temperature is higher than 77°F
(25°C), COOL is selected (set temperature: 75°F [24°C]). When the room
temperature is lower than 77°F (25°C), DRY is selected. However, when
operation is stopped and then started within 2 hours, the mode which has
been selected previously is operated.
Note:
. During COOL operation, the set temperature may not be changed when
the room temperature is more than 4°F (2°C) higher than the set tem-
perature. In this case, please wait until the room temperature drops to
within 4°F (2°C) of the set temperature.
. Auto Mode is not recommended if this indoor unit is connected to a MXZ
type outdoor unit.
0 COOL mode
Enjoy cool air at your desired temperature.
Do not operate COOL mode at low outside temperature
(less than 14°F [-10°C]).
Water condensed in the unit may drip and wet or damage furniture, etc.
6 DRY mode
Dehumidify your room. The room may be cooled slightly.
Temperature cannot be set during DRY mode.
FAN mode
Circulate the air in your room.
When the remote controller cannot be used...
Emergency operation can be activated by pressing the emergency operation
switch (E.O.SW) on the indoor unit.
Each time the E.O.SW is pressed, the operation changes in
the following order:
Operation indicator lamp
0 Emergency COOL
0 Stop
Set temperature : 75°F
(24°C)
Fan speed : Medium
Horizontal vane : Auto
Note:
The first 30 minutes of operation is test run. Temperature
centre1 does not work, and fan speed is set to High.
If a power failure occurs or the main power is turned off during operation, "Auto
restart function" automatically starts operation in the same mode as the one set
with the remote controller just before the shutoff of the main power. When
timer is set, timer setting is cancelled and the unit starts operation when power
is resumed.
If you do not want to use this function, please consult the service repre-
sentative because the setting of the unit needs to be changed.
En-5