Mitsubishi CS-31505 Owner's Manual page 84

Selecting the source of the PIP image
_Important:
You will probably want to use PIP tzl view two different pictures at
one time. To do this, you need to have two different ",sources." A
"source" is any signal that your TV is receiving through the an-
tenna terminals or through the input terminals.
On most TVs, you can only use the antennas attached to your TV
as one source; you must connect a VCR or another component to
see two different pictures.
However, because your TV has two tuners, you can watch two
different pictures without using a VCR. (You must have attached
antennas or cable systems to both the ,_mtenna-A (ANT-A) and
Antenna-B (ANT-B) terminals on your TV. (See the connection
diagaram in Chapter 2.)
Because of the ease of using Two-Tuner PIP, your TV will auto-
matically use Antenna-A and Antenna-B as the two sources.
However, you might want to change the source of the PIP image to
view the picture from a VCR or a:nother component.
To change the source of your PIP image:
(::2_ C:D C:21 _
c::_(2::D_
QOO O
0C23C=30
c_O © Oc_
_::_ £,) L,,) LJ kl
¢=::=_ {:) o tD
Repeatedly press the SOURCE
button on the remote control.
The PIP image will change
sources as follows:
LAnt-A ---* Input-1 -_ Input-2--*Ant-BJ
You can identit_¢ the source of the
PIP image from the display that
appears above it.
If you are not seeing a picture in
the PIP image, make sure that you
have made a connection to that
particular input, and that the
component (if any) is turned on.
To change the main image while in PIP mode, press the input
button (INPUT) on the control panel or on the remote control.
86
Chapter 4: Using the Special Features