Maytag MHW3000BG0 Use & Care Manual page 12

USING YOURWASHER
1 2, Touch and hold START to begin
wash cycle
hold to start
Touch and hold START to start the wash cycle. To pause
a cycle in progress, touch START once, then touch and
hold again to continue the cycle. To cancel a cycle, touch
POWER/CANCEL
Once you touch and hold START, you will hear the door lock,
unlock, and lock again. The washer door will remain locked during
the wash cycle.
Unlocking the door to add garments:
If you need to open the door to add 1 or 2
missed garments, you may do so while the
"Add a Garment" light is lit.
Touch START once; the door will unlock
once the washer movement has stopped.
This may take several minutes. Then close
door and touch and hold START again to
restart the cycle.
1 add a garment
hold to start
f
13.
Remove garments promptly
after cycle is finished
between the tub and the washer drum.
If you will be unable to remove the load promptly,
use the Fresh Spin
TM
option. If selected, the Fresh ,, _rtsh
Spin
TM
option will tumble the load periodically for sp_n
up to 6 hours. To turn off the Fresh Spin
TM
option,
touch POWER/CANCEL To set the washer so that the Fresh Spin
TM
option does not come on for future cycles, touch Fresh Spin.
NOTE:
m The door will remain locked while the Fresh Spin
TM
option is
active, To cancel the option and unlock the door, touch POWER/
CANCEL,
[] A small amount of water may remain in the dispensers after the
wash cycle is complete. This is normal.
[] This washer has a tight seal to avoid water leaks. To avoid odors,
leave the door open to allow the washer to dry between uses.
12