Maintenance - Maytag CRG9700C User Manual

MAINTENANCE
Electrical Connection
Appliances which require electrical power are equipped
with a three-prong grounding plug which must be
plugged directly into a properly grnunded three-hole
120 volt electrical outlet.
If an ungrounded, two-hule or other type electrical
outlet is encountered, it is the personal
responsibility
of the
appliance owner
to have
reeeptaele replaced with a properly grounded
three-hole electrical outlet. The three-prong
grounding plug is provided for protection against shock
h_ards, Do not cut or remove the third grounding
prong from the power cord plug.
Always disconnect power to appliance before servicing.
Proportional Valve Adjustment
Proportional valves have an adjusting screw located
inside the valve stem. Valves that do not have this screw
cannot be adjusted.
The WARM setting should prodnce a stable flame when
tnrning the knoh from IIIGH to WARM. The flame
shonkl be 1/8 inch or lower and must be stable on all
ports.
To adjust: Operate burner on HICII for about 5
minutes to preheat burner cap. Turn knob hack to
WARM; remove knob, and insert a small screwdriver
into the center of the valve stem. Adjust flame size by
turning adjustment screw in either direction. Flame
nmst be of sufficient size to be stable on all burner
ports. If flame adjustment is needed, adjust ONLY on
the WARM setting. Never adjust flame size on a higher
setting.
I
NOTE: All gas adjustments should be done by a [
qualified servicer only.
I
Leveling Legs
Some floors are not leve!. For proper haking, your range
must be level. The leveling legs are located on each
corner of t!le base of the range. Level the range by
tnrning
the
legs.
--_ lol.t s
WAIINING: To reduce the risk of accidental
tipping of the range, it must be secured by an anti-
tip device. To check if the device is installed
pmlmrly, use a flashlight and look underneath the
range to see that one of the rear leveling legs is
engaged in the bracket slot. The anti-tip device
secures the rear leveling leg to the floor, ff properly
engaged.
Light Replacement
Before replacing the oven or panel light bulb,
disconnect power to range. Be sure the bulh and
range parts are cool, l)o not touch a hot bulb with a
damp cloth as the bulb may hreak.
To Replace Panel Light (select models)
Grasp the top trim of" the baek panel with your thnulbs
under the fi'unt edge and pull outward while li{'ting the
trim. Remove the bulb and replace it with an 18 watt
fluol_scent tube. Snap the top trim back into place and
restore the power. Reset the clock.
mmm_I
1
To Replace Oven Light
Care{hlly unscrew the lens cover (select models) with a
dry' potholder. Ve_T carefldly remove the bulb with the
potholder. Replace with a 40 watt appliance bulb.
Recxmnect the power to the range and reset the clock.
PAGE 16