Pentax Optio WG-1 GPS Operating Manual page 111

8
/
8
9
/0
H
Set the number of shots.
1 Press the four-way controller ( • ).
2 Use the four-way controller (• •) to set [Number of Shots],
then press the four-way controller (•).
The frame returns to [Number of Shots].
Press the four-way controller (T).
The frame moves to [Start Delay].
Set the start delay.
1 Press the four-way controller (•).
2 Use the four-way controller (• •) to set the hours, then press
the four-way controller ( • ).
3 Use the four-way controller (• •) to set the minutes, then press
the four-way controller ( • ).
The frame returns to [Start Delay].
Press the MENU button.
ii!i!!i!i!i!_!
iiiii_ii_!iiiSii!
_i_!i_i_iii!_ii_i!iiii
iiiiiiiii!!iii!_
!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!
The [Interval Shoot] settings are saved and the camera returns to capture mode.
Press the shutter release button halfway.
The focus frame on the display turns green if the subject is in focus.
Press the shutter release button fully.
Interval shooting starts.
The LCD turns off between shots (during standby). Press the power
switch during standby to display the remaining number of shots and
interval on the monitor.
The [Stop interval shooting?] message is displayed when the power
switch and then the MENU button are pressed during standby.
Pressing the OK button cancels interval shooting.
• Interval Shoot is unavailable in _ (,Auto Picture), g (Green),
IIIIII (Digital Panorama), _I_ (Digital Wide), _{_:_ (Fireworks) and
(Voice Recording) modes.
• Even if an alarm is set. the alarm will not ring during interval shooting.