Pentax Optio WG-1 GPS Operating Manual page 109

Hide thumbs Also See for Optio WG-1 GPS:
Table of Contents

Advertisement

3
4
Use the four-way controller
(• _) to select i3s or § and
press the OK button.
The self-timer
lamp begins to blink
slowly and the camera is ready to take
a picture with the remote control.
When the camera detects
a person's
face, the Face Detection
function
is activated
and the face detection
frame appears
(p.80).
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
Point the remote control at the remote control receiver
and press the shutter release button on the remote
control.
The focus frame turns green when the subject is in focus and the
camera
takes a picture at the following
timing.
When i3s (3-sec Remote
Control)
is selected:
The self-timer
lamp and the macro lights blink quickly and the
camera takes a picture after about three seconds.
When
J (0-sec Remote
Control)
is selected:
The camera takes a picture immediately.
• The operating range is approx. 4 m (13 ft) from the front of the camera
when using the remote control unit.
• In ,1_ (Movie) mode, pressing the shutter release button again stops
the recording,
• The camera takes a picture even if the focus is not achieved.
• If the shutter release button on the camera is pressed halfway during
the countdown, the countdown stops. If the shutter release button on
the remote control is pressed again, the camera starts the countdown
again
• i3s/i cannot be selected in O (Green) mode.
• The self-timer lain p does not flash in _
(Pet) mode.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents