Panasonic Omnivision PVQ-V200 Operating Instructions Manual page 4

Congratulations
on your purchase of one of the most sophisticated and
reliable products on the market today. Used properly,
it will bring you and your iarnily years ot enjoyment.
Please fill in the information below, The serial number
is on the tag located on the back of your VCR.
• Date of Purchase
• Dealer Purchased From
• Dealer Address
• Dealer Phone No.
• Model No. __
• Serial No.
If your TV has AUDIO and VIDEO IN terminals, connect
them to VCR for higher quality picture and sound.
Connect VCR and iV with an AV Cable (not supplied) or a
RF Coaxial Cable (supplied) as shown in the figure below.
ANTENNA (See page 5)
CABLE TV
PUTDOOR ANTENNA INDOOR ANTENNA
[] Remote Control
LSSQ0207
[] Batteries 2 "AA"
(:_ O i,
[] RF Coaxial Cable
VJAS0196
I! ¸
To order accessories, call toll free
1-800-332-5368.
2) nsert the
batteries as
marked.
f) Open the cover.
3} Close _he cover.
[] Battery replacement caution
• Do not mix old and new batteries.
• Do not mix alkaline with manganese batteries,
4
VCR
Disconnect antenna
or cable from TV and
eo noc,,oVC
IN FROM ANT !
0 (_ VH,,U.,
a, AVCAS'EI b' ALI
_not supp_i.d) | | CABLEI
_. .,i, ,.I-, VHF/]
_NLt; q.; UHFt
o. 0 0
]i wDEO Auo,o
TV _,,:__,> :
Connect VCR
to TV with RF
Coaxial Cable.
1) While connection b) (above) is sufficient, connection
a) offers better sound and picture.
2) For both connections e) and b) proceed as follows:
• To use VCR : VCR Power on, set TV to VIDEO.
• To watch TV : VCR Power off, select channel on.
3) Set VOR Outpu', to channel 3 or 4 (not an active
station). (See page 6,)
Note to CABLE system installer:
This em nder is provided to Gall the CABLE system instatleT's al_en_io_
Ito Art c e 820-10 of the NEC in USA (and to the Canadian Electrical Code
Jin Canada) thai provides guidelines for proper grounding and, in
particular, specifies that the cable ground shall be connected to the
g_oun_ng system of the bui=ding, as dose to the point of cable entry as
practical.
WARNING ]
When using "Nut type" RF coaxial cables, tighten with lingers
only. Overtightening may damage terminals.