Closing Up The Tape-End Unrecorded Sections (Last Fade); One-Touch Editing Operation; To Record With Desired Tone Quality; To Specify The Tracks To Be Edited - Technics SC-CH717 Operating Instructions Manual

Closing up the tape-end unrecorded sections
(LAST FADE)
AST FADE Press LAST FADE.
I
Lights.
The recording will start after the system completes steps 2-3 of
"One-touch operation" below.
Use this editing mode when you record the tracks numbering higher
than 24.
You can edit the desired tracks of the desired disc(s) using this
editing mode. (See "Program edit recording" on page 36.)
fAv_'_
To cancel one-touch editing:
Press [] on the cassette deck.
The compact disc changer also stops.
One-touch editing operation:
1. The cassette deck will fast-forward and rewind to measure its
length. At the same time, CCRT function will be activated.
(See page 31 .)
2. The cassette deck will automatically advance the tape beyond
the leader tape, and then stop.
3. The compact disc changer automatically scans for the peak
(highest) level of the entire disc (Automatic Tape Level Set-
ting--ATLS), then recording will start. ATLS is the function which
scans (fast search) for the peak (highest) level of the disc, and
sets the appropriate recording level. When ATLS is activated, no
sound will be heard.
It takes about 70 seconds to complete ATLS for a compact disc of
60 minutes.
When there are tracks allotted on tape side B:
The cassette deck will continue recording a blank portion on tape
side A until the end of the side.
To record with desired tone quality:
Select the desired tone quality (see pages 42-44), and start editing.
To play back such recordings, press ON/FLAT on the tuner/sound
processor to set to FLAT.
To specify the tracks to be edited:
You can specify the tracks to be edited using the program play
procedure. (See page 22.)
After completing step 5 on the previous page:
1. Press PROGRAM on the remote control, and then specify the
tracks to be recorded in the desired sequence.
2. Press one of the one-touch editing buttons (ALBUM, J.FIT, LAST
FADE) to start editing.
You can program up to 24 tracks (and also tracks numbering lower
than 24).
"FULL" appears on the disptay if you try to program more than
24 tracks.
After the edit recording has finished:
When one disc is loaded:
The deck automatically enters the recording standby mode. When
"LINK" indicator flashes, it means you can edit tracks from the same
or another disc in succession. (See page 37.)
When two or three discs are loaded:
When there is a blank portion on the tape, the deck will automatically
start recording from the next compact disc.
When "LINK" indicator flashes after recording of all the loaded discs
has finished, it means you can edit tracks from the same or another
disc(s) in succession.
To finish recording:
Press [] on the compact disc changer and "LINK" indicator goes off.
35